45
A Crane Co. Company
420 Third Street
83 West Drive, Bramton
Piqua, Ohio 45356
Ontario, Canada L6T 2J6
Phone: (937) 778-8947
Phone: (905) 457-6223
Fax: (937) 773-7157
Fax: (905) 457-2650
www.cranepumps.com
Limited 5 Year Warranty
Municipal Wastewater
Crane Pumps & Systems
off ers a Commercial Warranty covering parts and labor on its pumps to this original end purchaser, when
used in permanent installations in compliance with requirements of the Barnes Catalog and Technical Manual specifi cations for
pumping municipal wasterwater or similar abrasive free, non corrosive liquids against defects in workmanship and material for the
period as defi ned below.
In the event that the pump is provided with moisture and/or temperature sensors, these must be in use in order to validate this
warranty. Barnes SH series Non-Clogs, SE series Non-Clogs, Wet End of XSE series Non-Clogs (Motor has a one (1) year warranty
and is the sole responsibilty of Reliance Electric), Effl uent and Sump pump models are Warranted for sixty (60) months (or 10,000
hours of operation) from the date of manufacture from Crane Pumps & Systems to the End Purchaser as follows: Crane Pumps &
Systems will pay the following share of the cost of replacement parts and labor provided the pump, with cable attached, is returned
prepaid to an Authorized Service Station as decided by Crane Pumps & Systems and its Municipal Market Distributor.
Warranty Period *
Time After Manufacture (months): 0 - 18
19 -39
40 -60
Run Time (hours):
0 - 3,000
3,001 - 6,500
6,501 - 10,000
Warranty:
100%
50%
25%
* Time After Manufacture (months) or Run Time (hours) shall be determined by an Authorized Service Station and/or current copy of
maintenance. If run time documentation cannot be produced then date of manufacture prevails.
Start-up reports and electrical system schematics (including Bills-of-Material) may be required to support any Warranty claims.
This Warranty shall not apply to any product or part of product which has been subject to misuses, negligence, accident, operation
outside of our published hydraulic curve parameters, used in a manner contrary to printed Instructions, or damaged due to a
defective power supply, improper electrical protection, excessive abrasive wear or faulty installation or repair.
THE SOLE AND
EXCLUSIVE REMEDY FOR BREACH OF ANY AND ALL WARRANTIES WITH RESPECT TO ANY PRODUCT SHALL BE TO
REPLACE OR REPAIR AT OUR ELECTION, F.O.B. POINT OF MANUFACTURE OR AUTHORIZED REPAIR STATION, SUCH
PRODUCTS AND/OR PARTS AS PROVEN DEFECTIVE. THERE SHALL BE NO FURTHER LIABILITY, WHETHER BASED ON
WARRANTY, NEGLIGENCE OR OTHERWISE.
Crane Pumps & Systems neither assumes nor authorizes any person or company to assume for it, any other obligation in correction
with the sale of its equipment. Any enlargement or modifi cation of this Warranty by a Representative or other Selling Agent shall
become HIS or HER exclusive responsiblity.
UNDER NO CIRCUMSTANCES WILL WE BE RESPONSIBLE FOR ANY OTHER DIRECT OR CONSEQUENTIAL DAMAGES,
INCLUDING BUT NOT LIMITED TO TRAVEL EXPENSES, RENTED EQUIPMENT, OUTSIDE CONTRACTOR FEES, UNAUTHORIZED
REPAIR SHOP EXPENSES, LOST PROFITS, LOST INCOME, LABOR CHARGES, DELAYS IN PRODUCTION, IDLE PRODUCTION,
WHICH DAMAGES ARE CAUSED BY ANY DEFECTS IN MATERIAL AND\OR WORKMANSHIP AND\OR DAMAGE OR DELAYS IN
SHIPMENT. THIS WARRANTY IS EXPRESSLY IN LIEU OF ANY OTHER EXPRESS OR IMPLIED WARRANTY, INCLUDING ANY
WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE
.
The following information must be completed to validate warranty. (Certain data will be provided before order placement and
additional data following shipment).
Pump Model/Serial #: _______________________________ Job Name: ___________________________________
Sales Order #: ____________________________________ Date: _______________________________________
Factory Authorized Signature: ________________________________________ Title: _______________________
