Crane Merchandising Systems Merchant 180, Operator'S Manual

Page: 31 / 170

Merchant™ Operators’ Guide Initial Setup
1810006 23 January 2008
Installing Trays in the Merchandiser
Study this procedure before you install a tray for the first time; while you are holding the tray you will
not be able to see this area.
Proceed as follows:
1. Place the back of the tray in
the machine so the back tabs
on the tray are behind the tray
rail rollers.
2. Slide the tray straight back into
the machine, insuring that the tray
axle stop is engaged in the tray
rail. Keep pushing the tray back
until it hits the front stop.
3. Lift the front of the tray, so the
stop built into the tray clears the
roller. Push the tray forward and let
it return to horizontal. It will “lock
in” to place.
4. Load the tray harnesses into the
cabinet, over the tray rail and into
the cabinet behind the slide out
monetary. Reach through the hole
provided in the monetary section
and grab the tray harness. Plug
the Tray harness into the correct
PCB tray harness header.
5. Slide the harnesses up into the
round hole provided and secure
them with the plastic grommet. Pull
the slack of the harnesses back
into the cabinet.