Crane Merchandising Systems Merchant 180, Operator'S Manual

Page: 17 / 170

Merchant™ Operators’ Guide Initial Setup
1810006 9 January 2008
Initial Set-Up
Moving the Merchandiser Through a Narrow Doorway
NOTE
If necessary, this merchandiser can be moved through an opening as
narrow as 30 inches by removing panels at the top and bottom of the cabinet.
REMOVING THE TOP PANEL
(
Refer to Figure 1 at right. )
1. Remove the two screws that
secure each end of the panel to
the cabinet.
2. Pull the panel forward to remove it
from the merchandiser.
REMOVING THE LOWER PANEL
AND DELIVERY BIN
(
Refer to Figures 2 and 3 at right.)
1. Open the slide-out monetary and
the glass door. Locate the silver
tab of the delivery bin latch on the
lower delivery bin side of the
monetary wall.
2. Lift the latch up to allow the
delivery bin assembly to hinge
down.
3. Lift up the delivery bin slightly and
lift up on the drop rods to allow the
rods to clear the stop brackets.
4. Slide the delivery bin assembly to
the right to clear the hinges. The
delivery bin assembly will not be
attached to the machine.
5. Unhook the SureVend™ harness
at the SureVend™ board, noting
the wire routing.
6. Remove the screws that secure
the bottom panel to the cabinet.
7. Pull the panel forward to remove it
from the cabinet.
Figure 1
Figure 2
Figure 3
NOTE
To fit the merchandiser through
some of the most narrow doorways,
you may have to remove the trays.
If you do, follow the procedure as
outlined on the following page.