FEATURES
Your garage door opener is equipped with features to provide you
with greater control over your garage door operation.
myQ
® (DO NOT ENABLE ON ONE-PIECE DOORS)
myQ
®
technology uses a 900 MHz signal to provide two-way
communication between the garage door opener and myQ
®
enabled
accessories. Your garage door opener is compatible with up to 8
myQ
®
accessories.
FOR MODELS CMXEOCG772 AND CMXEOCG982
TIMER-TO-CLOSE (DO NOT ENABLE ON ONE-
PIECE DOORS)
The Timer-to-Close feature automatically closes the door after a
specified time period that can be adjusted using the door control.
Prior to the door closing there will be an audible and visual alert.
REMOTE CONTROLS AND DOOR CONTROLS
Your garage door opener has already been programmed at the
factory to operate with your remote control, which changes with each
use, randomly accessing over 100 billion new codes.
myQ
®
Accessories
MEMORY CAPACITY
Remote Controls
Up to 8
Door Controls
Up to 2 myQ
®
door controls
Wireless Keypads
Up to 1
THE SAFETY REVERSAL SYSTEM
When properly connected and aligned, the safety reversing sensors
will detect an obstruction in the path of the infrared beam. If an
obstruction breaks the infrared beam while the door is closing, the
door will stop and reverse to full open position. If the door is fully
open, and the safety reversing sensors are not installed, or are
misaligned, the door will not close from a remote control. However,
you can close the door if you hold the button on the door control or
wireless keypad until the door is fully closed. The safety reversing
sensors do not effect the opening cycle.
LIGHTS
The garage door opener light bulbs will turn on when the opener is
initially plugged in; power is restored after interruption, or when the
garage door opener is activated. The lights will turn off automatically
after 4-1/2 minutes. An incandescent A19 light bulb (100 watt
maximum) or for maximum energy efficiency a 26W (100W
equivalent) compact fluorescent light (CFL) bulb may be used.
LED bulbs may cause remote control radio interference. Model
CMXEOCG982 comes equipped with 2 LED bulbs. We recommend
use of these bulbs as replacements so transmitter range is not
reduced.
FOR MODEL CMXEOCG982
BATTERY BACKUP
The battery backup system allows access in and out of your garage,
even when the power is out. When the garage door opener is
operating on battery power, the garage door opener will run slower,
the light will not function, the Battery Status LED will glow solid
orange, and a beep will sound approximately every 2 seconds.
USING YOUR GARAGE DOOR OPENER
The garage door opener can be activated through a wall-mounted
door control, remote control, wireless keypad or myQ
®
accessory.
When the door is closed and the garage door opener is activated the
door will open. If the door makes contact with an obstruction while
opening, the door will stop, opener beeps and lights flash 5 times.
When the door is in any position other than closed and the garage
door opener is activated, the door will close. If the garage door makes
contact with an obstruction while closing, the door will reverse,
opener beeps and lights flash 5 times. However, you can close the
door if you hold the button on the door control or wireless keypad until
the door is fully closed.
The safety reversing sensors do not affect the opening cycle. The
safety reversing sensor must be connected and aligned correctly
before the garage door opener will move in the down direction.
34
