31
Traction Drive Cable
1. Remove the gas from the gas tank. Stand the snowthrower up on the
front end of the auger housing.
WARNING: Drain the gasoline outdoors, away from fire
or flame.
2. Loosen the bolts (A
A, Figure 40) on each side of the bottom panel (B
B).
3. Remove the bottom panel.
4. Disconnect the “Z” fitting from the drive lever.
5. Slide the cable boot (A
A, Figure 41) off the cable adjustment bracket
(B
B).
6. Push the bottom of the traction drive cable (C
C) through the cable
adjustment bracket until the “Z” hook (D
D) can be removed.
7. Remove the “Z” hook from the cable adjustment bracket. Move the “Z”
hook down to the next adjustment hole.
8. Pull the traction drive cable up through the cable adjustment bracket.
9. Put the cable boot over the cable adjustment bracket.
10. Install the the “Z” hook to the traction drive lever.
11. To check the adjustment, depress the drive lever and check the length
of the drive spring (A
A, Figure 42). In correct adjustment, the length
of the drive spring is a minimum 3 inches (76 mm) and a maximum
3-3/8 inches (85 mm).
12. Install the bottom panel (B
B, Figure 40).
13. Tighten the bolts (A
A) on each side of the bottom panel.
Traction Drive Cable
Figure 41
“A”
Adjusting Traction Drive Cable
Figure 40
A
C
D
B
Check Adjustment of Traction Drive Cable
Figure 42
A
A
B
MAINTENANCE
Not
for
Reproduction
