DiviDer iNstallatioN
items Needed:
10-24 x 5/16 Hex Screw (Qty: 8)
dividers (Qty: 6)
5/16" wrench
process:
• decide which position and in which drawers they would
best serve your needs.
• The dividers are cut to fit right to left in the drawers. if you
prefer to run them front to back, they may be trimmed in
length to do so.
• Position the dividers in the desired locations.
• Thread screws through the bottom of the drawer and into
each divider. Tighten all the screws.
DraWer liNer iNstallatioN
items Needed:
drawer Liner Roll
Scissors
process:
• Remove the non-slip drawewr liner from the roll. The
drawer liner may be cut with scissors to fit each drawer
and around the drawer divideres, if necessary.
chest attachmeNt (if purchased)
items Needed:
5/16-18 x 1 Hex Screw (Qty: 4) [included with chest]
5/16 wrench
process:
• Remove the wooden top from the cart.
• Remove the top two drawers of the cart (refer to the
drawer removal instructions).
• Lift the chest onto the cart. Line up the holes in the bot-
tom of the chest with the holes in the top of the cart.
• Attach the chest using (4) screws inserted from the
underside of the top of the cart. (See Figure 8)
• wrench tighten all screws.
• Replace the drawer (refer to drawer installation instruc-
tions).
• To remove, reverse procedure.
operatioN
Figure 4
Handle Lever
locKiNG aND uNlocKiNG the uNit
locking the unit:
• Pull handle lever out.
• insert the key into the lock and turn it clockwise.
• Release lever.
• if the drawers do not open, push all the drawers com-
pletely closed to release the lockbars
Figure 5
unlocking the unit:
• Always check the unit to make sure all the drawers are
completely closed before locking.
• Pull the handle lever.
• insert key into the lock and turn it counterclockwise.
• Release lever.
3
Screw
drawer
dividers
Figure 3
