Super Shot 60 Propane Melter Part Manual
Chapter 8 Troubleshooting
©2018 by Crafco, Inc. All Rights Reserved
………………...…………………………..……………...Illustrated Parts List 8-8
8.0.2. Burner Ignitor Proper Spacing and Function
Step
Burner Troubleshooting
1
Turn off the propane gas at the bottle and open the inspection door on the driver’s side rear
of the tank.
WARNING
2
Allow some distance at least a foot or two between you and the opening of the inspection
door in case any unused propane gas should ignite.
3
Have a second person turn “ON” the main power toggle switch as you watch the spark on the
ignitor through the inspection door. This should be repeated several times to insure a
consistent spark.
4
The spark should be strong and at the tip of the ignitor between the center post and the post
to the left of it. If the ignitor is bent properly the spark will be approximately 1” above the
burner opening where the propane exits the burner.
Note:
Prior 2018 the ignitors had to be bent in the field.
5
If you see the spark occurring anywhere else, then check the ignitor tip spacing, there should
be approximately a
1/8” gap between the center grounding post and both spark post and the
sensor post. All three should be slightly bent towards the burner.
6
If the ignitor gap is correct, then unbolt the ignitor and burner assembly and clean all
mounting surfaces to insure a good grounding contact, and then reassemble.
7
Check both electrical connectors for the spark and sensor; these both need to be clean from
any corrosion and a tight fit to the ignitor spades.
Table 8-7 Burner Ignitor Proper Spacing and Function
Summary of Contents for SUPER SHOT 60
