Crafco SUPER SHOT 60, Parts Manual

Page: 67 / 140

Super Shot 60 Propane Melter Part Manual
Chapter 8 Troubleshooting
©2018 by Crafco, Inc. All Rights Reserved
………………...…………………………..……………...Illustrated Parts List 8-1
8.0 Burner Troubleshooting
8.0.1. Symptoms: Burner will Not Ignite
Note : Use Fig. 8-1 Propane Burner Schematic while troubleshooting the burner electrical system.
Step Possible Cause If . . .
1 Start Troubleshooting at the control box. Is
the Kohler engine running?

Yes, go to Step 2.

No, start the Kohler engine.

Note : You can troubleshoot the burner
without the engine running, but you must
connect a battery charger to the battery and
the main power toggle swtich must be in the
“ON” position.
2
Is the “POWER” toggle switch in the “ON”
position?

Yes, go to Step3.

No, turn the toggle switch to the “ON”
position.
3 Are both the Material and Hot Oil
temperature dials set to proper operating
temperatures?

Yes, go to Step 4.

No, set the Material according to the type of
sealant you are using and the Hot Oil 100°F
above the Material set point.
4 Are both the Material and Hot Oil
temperature displays reading a three digit
positive number?

Yes, go to Step 5.
No, go to Table 8-3 Burner Electrical
Troubleshooting , Step 1.
5 Is the red "Burner" light "ON"?

Yes, go to Step 6.
No, go to Table 8-3 Burner Electrical
Troubleshooting , Step 1.
6 Is
amber light “ON” on the din plug located
on the propane valve?

Yes, go to Step 7.

No, go to Table 8-3 Burner Electrical
Troubleshooting , Step 1.
7 Is the propane tank full?

Yes, go to Step 8.

No, fill your tank or make sure you have
enough fuel for the day.
8 Is the valve on the propane tank open?

Yes, go to Step 9.

No, open valve to allow propane to flow to
the ball valve on the hose.
Table 8-1 Basic Visual Troubleshooting