Super Shot 60 Diesel Melter Part Manual
Chapter 8 Troubleshooting
©2016 by Crafco, Inc. All Rights Reserved
………………...………………………………..……………...Troubleshooting 8-30
NOTE:
Use
Figure 8.11 Pump Circuit Schematic
while troubleshooting the pump electrical system.
Step
Possible Cause
If . . .
1
Is the Material Temperature at or above 275°F?
Yes go to Step 2.
No, continue to allow the machine to
heat.
2
Is there 12 Vdc between the Hose PAKSTAT
terminal #2 purple wire and terminal #8 black
ground wire?
(Refer to the pump circuit schematic
).
Yes, go to Step 3.
No, go to Step 2a.
2a
Is there 12 Vdc between the Hose PAKSTAT
terminal #1 pink wire and terminal #8 black
ground wire?
Yes, check for a broken wire or poor
wire crimp on the terminal #2 purple
wire and recheck for 12 Vdc. (If still no
voltage replace the Material
PAKSTAT.)
No, go to Step 2b.
2b
Is there 12 Vdc between the Hose PAKSTAT
terminal #9 pink wire and terminal #8 black
ground wire?
Yes, check for a broken wire or poor
wire crimp on terminal #1 pink wire.
(If you have 12 Vdc on terminal #9
pink then you must have 12 Vdc on
terminal #1 pink wire; they are the
same wire.)
No, if this is the case you would
have had a hose heating issue.
3
Is there 12 Vdc between the terminal block
purple wire and the terminal black ground wire?
Yes, go to Step 4.
No, check for a broken wire or poor
wire crimp between the Hose
PAKSTAT terminal #2 purple wire and
the terminal block purple wire.
4
Move to the junction box at the rear of the
machine and open the cover.
Is there 12 Vdc between the trigger red wire
coming from the control box and a nearby
ground source?
Yes, go to Step 4a.
No, check for a broken wire or poor
wire crimp between the junction box
and the control box red wire labeled
red-trig.
4a
Is there 12 Vdc between the trigger red wire
going toward the hose (just above where you
checked in Step 4) and a nearby ground
source?
Yes go to Step 4b.
No, check for a broken wire or poor
wire crimp on the red trigger going
toward the hose.
Table 8-26 Pump Electrical Troubleshooting
Summary of Contents for SS60-Diesel
