Crafco SS60-Diesel, Manual

Page: 62 / 119

Super Shot 60 Diesel Melter Part Manual
Chapter 8 Troubleshooting
©2016 by Crafco, Inc. All Rights Reserved
………………...………………………………..……………...Troubleshooting 8-14
Step Possible Cause If . . .
4a Is there 12Vdc between the Material
PAKSTAT terminal #2 pink wire and terminal
#8 black ground wire?
(Refer to Figure 8.5 Mixer Circuit Schematic ).

Yes, check for loose connections or broken
wires between PAKSTAT terminal #2 and
terminal block.

No, go to Step 4b.
4b Is there 12Vdc between the Material
PAKSTAT terminal #1 orange wire and
terminal #8 black ground wire?

Yes, replace the Material PAKSTAT.

No, go to Step 4c.
4c Is there 12Vdc between orange wire labeled
ORN-1, terminal #9 and terminal #8 ground
source (black wire)?

Yes, check for loose connections or broken
wires between terminals #8 and #1.

No, go to Step 5.
5 Is there 12Vdc at orange wire labeled ORN-1
and ORN-2 on the terminal block?

Yes on both, check for loose connections or
broken wires between terminal block and
material PAKSTAT.

Yes on ORN-2 and No on ORN-1 replace
terminal block.

No on both, go to Step 6.
6 Is there 12Vdc between orange wire labeled
ORN-2 terminal #3 and terminal #5 black
ground of hot oil PAKSTAT?

Yes, check for loose connections or broken
wires between terminal #3 and terminal
block.

No, go to Step 7.
7 Is there 12Vdc between top terminal of the
power switch and a nearby ground (black
wire)?

Yes, check for loose connections or broken
wires between toggle switch and hot oil
PAKSTAT terminal #3.

No, go to step 7a.
7a Is there 12Vdc between bottom terminal wire
labeled RED-3 and a nearby ground source
(black wire)?

Yes, replace toggle switch.

No, go to Step 8.
8 Is there 12Vdc between the top terminal of
circuit breaker red wire labeled RED-3 and
nearby ground source (black wire)?

Yes, check for loose connections or broken
wires between circuit breaker and toggle
switch.

No, go to Step 8a.
8a Is there 12Vdc between the bottom terminal
of circuit breaker red wire labeled RED-2 and
nearby ground source (black wire)?

Yes, replace circuit breaker.

No, go to Step 9.
Table 8-16 Mixer Electrical Troubleshooting (continued)