19 December 2019
Document Part: 170825-000
SAFETY, REGULATORY, AND WARRANTY GUIDE
CRADLEPOINT E300-C18B
MODEL: S5A946A
CRADLEPOINT E300-C4D
MODEL: S5A947A
CRADLEPOINT E350-C4D
MODEL: S5A952A
WITH OPTIONAL PLUG-IN MODULES:
CRADLEPOINT MC400LP4
MODEL: MC400LP4
CRADLEPOINT MC400LP5
MODEL: MC400LP5
CRADLEPOINT MC400LP6
MODEL: MC400LP6
CRADLEPOINT MC400-600M-C
MODEL: MC400-600M-C
CRADLEPOINT MC400-1200M-B
MODEL: MC400-1200M
This important Safety, Regulatory, and Warranty Guide contains safety,
handling, disposal, regulatory, trademark, copyright, and software licensing
information.
Read all safety information below and operating instructions before using
the device to avoid injury.
FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
FCC CAUTION
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC STATEMENT
For product available in the USA/Canada market, only channel 1-11 can be
operated. Selection of other channels is not possible.
Operation on the 5150-5250 MHz and 5250-5350 MHz WiFi radios is restricted
to indoor use only.
FCC RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance of 20 cm between the radiator and your body.
This device and its antennas(s) must not be co-located or operating in
conjunction with any other antenna or transmitter except in accordance
with FCC multi-transmitter product procedures.
To comply with FCC regulations and human exposure to RF radiation, the
maximum cellular antenna gain must not exceed 1dBi (619-970MHz)
and
2
dBi for channel operating higher than 1G.
INDUSTRY CANADA STATEMENT
This device complies with Industry Canada license-exempt RSS standards.
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
For product available in the USA/Canada market, only channel 1-11 can be
operated. Selection of other channels is not possible.
The device for the band 5150-5350 MHz is only for indoor usage to reduce
potential for harmful interference to co-channel mobile satellite systems.
INDUSTRY CANADA RADIATION EXPOSURE STATEMENT
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance of 2
5
cm between the radiator and your body.
These radio transmitters (IC:6921A-S5A946A, 5131A-LM960, 5131A-LM940,
2417C-MC7455, 2417C-HL7588, 10224A-2018EC25AF) have been approved by
Industry Canada to operate with the antenna types listed below with the
maximum permissible gain and required antenna impedance for each
antenna type indicated. Antenna types not included in this list, having a gain
greater than the maximum gain indicated for that type, are strictly
prohibited for use with this device.
These devices have been designed to operate with cellular antennas having a
maximum gain of 1dBi in 619-970MHz band and maximum gain of 2 dBi for all
other operation in higher than 1G bands. Antennas having a higher gain are
strictly prohibited per regulations of Industry Canada. The required antenna
impedance is 50 ohms.
This device and its antennas(s) must not be co-located or operating in
conjunction with any other antenna or transmitter except in accordance
with IC multi-transmitter product procedures.
DÉCLARATION D’INDUSTRIE CANADA
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage,
et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
Pour les produits disponibles aux États-Unis / Canada du marché, seul le
canal 1 à 11 peuvent être exploités. Sélection d'autres canaux n'est pas
possible.
les dispositifs fonctionnant dans la bande 5150-5350 MHz sont réservés
uniquement pour une utilisation à l’intérieur afin de réduire les risques de
brouillage préjudiciable aux systèmes de satellites mobiles utilisant les
mêmes canaux.
NOTE IMPORTANTE (POUR L’UTILISATION DE DISPOSITIFS MOBILES):
DÉCLARATION D’EXPOSITION AUX RADIATIONS
Cet équipement est conforme aux limites d'exposition aux rayonnements IC
établies pour un environnement non contrôlé. Cet équipement doit être
installé et utilisé avec un minimum de 25 cm de distance entre la source de
rayonnement et votre corps.
Cet appareil et son antenne (s) ne doit pas être co-localisés ou
fonctionnement en association avec une autre antenne ou transmetteur.
Le présent émetteur radio (IC:6921A-S5A946A, 5131A-LM960, 5131A-LM940,
2417C-MC7455, 2417C-HL7588, 10224A-2018EC25AF) a été approuvé par
Industrie Canada pour fonctionner avec les types d'antenne énumérés ci-
dessous et ayant un gain admissible maximal et l'impédance requise pour
chaque type d'antenne. Les types d'antenne non inclus dans cette liste, ou
dont le gain est supérieur au gain maximal indiqué, sont strictement
interdits pour l'exploitation de l'émetteur
.
Ces appareils ont été conçus pour fonctionner avec des antennes cellulaires
ayant un gain maximal de 1 dBi dans la bande 619-970 MHz et un gain
maximal de 2 dBi pour toutes les autres opérations dans des bandes
supérieures à 1G. Les antennes ayant un gain plus élevé sont strictement
interdites par les réglementations d'Industrie Canada. L'impédance d'antenne
requise est de 50 ohms.
INFORMATION FOR EUROPE, DECLARATION OF COMPLIANCE
Cradlepoint, Inc. 1111 W Jefferson St. Boise, ID 83702 USA
EU Authorized Representative: James Bristow, Senior Vice President, EMEA,
Cradlepoint UK Ltd. Cedar House, Apex Court, Camphill Road, West Byfleet,
Surrey, KT14 6SQ United Kingdom
Hereby, Cradlepoint Inc. declares that this equipment is in compliance with
the Radio Equipment Directive 2014/53/EU, Energy Related Products
Directive 2009/125/EC, and RoHS2 Directive 2011/65/EU.
The full text of the EU declaration of conformity is available at the
following internet address: Cradlepoint.com/product-certifications
RESTRICTIONS ON USE
5 GHz 802.11 a/n/ac WiFi radios are restricted to indoor use only. The
5GHz WiFi radio in this device must be powered OFF if the device is
installed outdoors, or if the device is installed in a vehicle.
RF Exposure Statement: To comply with RF Exposure requirements, this
equipment should be installed and operated with minimum distance of 20
cm between the radiating device and your body.
ACCESSORIES IMPACTING COMPLIANCE
To maintain compliance with EMC, Radio, and RF Exposure requirements,
use only Cradlepoint accessories intended for use with this product. All
Cradlepoint accessories intended for use with this product will maintain
EMC, Radio, and RF Exposure compliance when installed according to
instructions. Cellular antennas must have a gain 1.42dBi (619-970MHz), 0.88
dBi (1445-1515 MHz), 2.69dBi (17170-2700MHz), 4.13 dBi (3400-3700 MHz),
4.29 dBi (5150-5925MHz). 802.11 antennas must have a gain <5 dBi.
BE BG CZ DK DE EE IE
EL ES FR HR IT CY LV
LT LU HU MT NL AT PL
PT RO SI SK FI SE UK
for devices with detachable antenna(s), the maximum antenna gain permitted
for devices in the bands 5250-5350 MHz and 5470-5725 MHz shall be such that
the equipment still complies with the e.i.r.p. limit;
for devices with detachable antenna(s), the maximum antenna gain permitted
for devices in the band 5725-5850 MHz shall be such that the equipment still
complies with the e.i.r.p. limits as appropriate; and
pour les appareils avec antenne (s) détachable (s), le gain d'antenne
maximal autorisé pour les appareils dans les bandes 5250-5350 MHz et
5470-5725 MHz doit être tel que l'équipement soit toujours conforme à la
norme e.i.r.p. limite;
pour les appareils à antenne (s) détachable (s), le gain d'antenne maximal
autorisé pour les appareils dans la bande 5725-5850 MHz doit être tel que
l'équipement soit toujours conforme à la norme e.i.r.p. limites appropriées;
et