f
uncTion
BA_v2_colibri_ccTalk_EN_1-0
21
5.5
Control for external sorting device
To route the accepted coins either to the cash‑box or to change tubes or hoppers, for example,
you can fit the coin validator with the NRI s
2
SSD-3000 3-fold sorter or another sorting device.
5.5.1
Sorting principle
The sorting gates are controlled by two sorting lines on pins 3 and 4 of the 10-pin connector
8
] on the back of the device.
You set which coin is to be sorted on which sorting line by means of the machine's controller.
Assignment of coin type to sorting line as well as sorting time (for how long shall the sorting
gates be controlled? 300-1000ms).
While the coin validator is sorting an accepted coin (the sorting time), it cannot
accept any further coins unless the same ccTalk sorting path is addressed. If
external sorting is no longer needed and the sorting time is not set to zero, the
system continues to reduce the coin acceptance speed by the set sorting time.
This means that you should set the sorting time to zero for faster coin acceptance.
5.5.2
Sorting using NRI 3-fold sorter s
2
SSD-3000
There are three different versions of the NRI 3-fold sorter for the top entry version of the v
2
colibri
depending on the machine environment. They differ by virtue of the position of the return chute:
•
s
2
SSD-3001: Return chute in front of the right-hand sorting chute
•
s
2
SSD-3002: Return chute next to the right-hand sorting chute
•
s
2
SSD-3003: Return chute behind the right-hand sorting chute
The front entry version can be combined with the s
2
SSD-3004.
