CHPA
S
ERIES
D
OC
.01023245
R
EV
.R
THIS
DOCUMENT
IS
THE
PROPERTY
OF
COMMUNICATIONS
&
POWER
INDUSTRIES.
REPRODUCTION
OR
RELEASE
WITHOUT
EXPRESS
PERMISSION
IS
STRICTLY
PROHIBITED
5-11
Table 5-1. Front Panel Categories
Category Name
Purpose
RF Control
-RF Output Setting
-Attenuator Setting
-RF Power Mode
-RF Inhibit
-RF Display (W, dBW, dBm)
-Suppress Peak Mode (disables
RF peak mode metering)
Linearizer Control (optional)
-Gain
-Phase
-Amplitude
RF Trip Limits/Switch Port Relay
Settings
-High RF Alarm
-High RF Fault
-Low RF Alarm
-Low RF Fault
-High Reflected RF Fault
-Low RF Relay Preference
-Fault Relay Preference
Fault Log
Factory Authorized Access Code
Fault Trip Setting*
-Helix Over Voltage Fault
-Helix Under Voltage Fault
-Helix Avg Over Current Fault
-Helix Voltage Detect in Standby
Factory Tests*
Reset Elapsed Time Meters*
-Reset Heater Elapsed Time Meter
-Reset Beam On Elapsed Meter
Reset to Factory Defaults*
HVPS Test Mode**
User Tests
-Lamp Test
-Beeper Mute
-Aux Serial Port Loopback
Time/Date Set
-User Set Heater Time Delay
-12/24 Hour Format
-Hour:Minute
-Set Month
-Date
-Year
-US Daylight Savings
Remote Interface Parameters
Mode (If RMTPNL is displayed,
the other selections under this
menu will not be available.)
-Device Address
-Baud
-Parity
-Protocol
-Check Byte Type
-CR Enable
-LF Enable
-Accept Bad Check Byte
-Loopback Test
-Installation Test
Computer Interface (CIF)
Parameters
-Device Address
-Baud
-Parity
-Protocol
-Check Byte Type
-CR Enable
-LF Enable
-Accept Bad Check Byte
-Loopback Test
-Installation Test
