CPA 1041130, User Manual, Page: 10 / 21

BLUEFIRE HEAT PUMPS MANUAL
pag. 10 di 20
www.cpa-piscine.it
Ver.06 – 2018-05-28
When the heat pump is inactive, the display indicates the temperature
external environment
.
When the heat pump is on, the display indicates the temperature
of the incoming water and the temperature of the outgoing water.
By pressing the scroll up or down buttons it is possible to check the
parameters P1, P2 and ROOM
Parameter Description Range Visualization
IN
Inlet water temperature
-9
—
40°C
Detected temperature
OUT
Water temperature at the outlet
-9
—
40°C Detected temperature
P1
Primary circuit temperature -9
—
40°C Detected temperature
P2
Secondary circuit temperature -9
—
40°C Detected temperature
ROOM
Environmental temperature
-9
—
40°C Detected temperature
If no button is pressed within 5 seconds, the system automatically returns to its initial state.
WARNING
To change the value of the status parameters, the heat pump must be in stand-by and not
working.
Press the “SET” button once to d isplay the 13 status parameter selection menu.
Use
the “SET” button to view and scroll through the
13 parameters set in default and reach the field that you want to change (see
par. 4 - List of programming parameters).
The value is changed using the scroll keys (Up or Down Arrow).
To change the value of the desired temperature set point, simply use the scroll keys (0 cooling and
1 heating parameters).
To modify the remaining parameters (from 2 to C) it is necessary to press the scroll buttons (triangle up and
triangle down) at the same time. The digital controller will emit a beep, so it will be possible to change the
parameter value again using the scroll keys.
Press “SET” in order to memorize th e set value and pass to the next parameter.
2. WORK STATE CONTROL
3. STATUS MENU PARAMETERS PROGRAMMING