CZ-388 massage chair auto-check list
ON/OFF:
KNEAD + TAP + POWER
(buttons on the controler), press and hold the three buttons in two
senconds to turn on the automatic analysis system model.
After activating the "auto-checking model", the display screen of the controller keeps flashing; if there is
something wrong with the chair, the time area will show you the exact code of the malfunction, meanwhile the
buffer will make noise.
code
Phenomenon
Malfunction description
Solutions
Remarks
01
remote control tested any
key pressed more than 25
seconds
1.one of the KEY has
been blocked.
1.check the key of the
remote control
turn on the
chair
02
remote control did not
connected
1.the remote control wire
is broken or the remote
control wire is
disconnected
1.reconnecte the remote
control wire or change the
remote control wire.
turn on the
chair
03
backrest signal is
abnormity
1.backrest wire(black) is
not well connected.
2.up & down limit sensor
is broken
1.check whether the
backrest wire(black) is well
connected
2.change the up & down
limit sensor
turn on the
chair
07
tested more than 2 wideth
inspection signal
1.wideth inspection board
is broken
2.wideth inspection wire
is not well connected
1.change wideth inspection
board
2.change backrest
wires.(black)
activate the
Rolling
function
08
more than 5 seconds did
not tested the wide signal
1.wideth inspection board
is broken
2.the wire connect to the
wideth inspection board is
disconnected
3.kneading motor is
broken or kneading belt is
lost
1.change wideth inspection
board
2.change backrest
wires.(black and gray)
3.change kneading motor
activate
auto-check
model
09
more than 5 seconds did
not tested the middle
signal
1.wideth inspection board
is broken
2.the wire connect to the
wideth inspection board is
disconnected
3.kneading motor is
broken or kneading belt is
lost
1.change wideth inspection
board
2.change backrest
wires.(black and gray)
3.change kneading motor
activate
auto-check
model
