Server Health Check Probes
Enabling/Disabling Layer 3 ICMP Probes
Enable/Disable ICMP probes in the GUI
ICMP probes are enabled by default for all servers.
1. Verify that you are logged into the GUI. If not, log in as described in
2. Select the
Load Balance
configuration tab on the left navigational pane if it is not already
selected.
3. Click on a server on the left navigational pane and select a configured server.
4. In the right configuration pane, enable (or disable) the
Probe Layer 3
check box.
5. Click
Commit
.
Enable/Disable ICMP Probes in the CLI
ICMP probes are enabled by default for all servers.
1. To enable ICMP probes for a server in the CLI enter the following:
eqcli >
server
servername
flags probe_l3
2. To disable ICMP probes for a server in the CLI:
eqcli >
server
servername
flags !probe_l3
642
Copyright © 2014 Coyote Point Systems, A Subsidiary of Fortinet, Inc.
Summary of Contents for Equalizer GX Series
