Coyote Point Systems Equalizer GX Series, Administration Manual

Page: 559 / 866

Configuring VLAN (Subnet) Failover Settings (GUI)
Configure subnets for failover using the GUI as follows:
1. Configure both Equalizers running EQ/OS 10:
a. Perform initial system configuration as outlined in
"Load Balancing & Networking"
on page 89.
b. Create all required VLANs, clusters, servers, etc., required for your con-
figuration.
c. Ensure that the configuration is working properly. In particular, make sure that
at least one server is active (that is, marked "up" in the GUI). Failover will not
properly initialize if Equalizer cannot successfully probe at least one server.
2. Configure VLANs and subnets on both units; they must be exactly the same as noted above
under
"Failover Constraints"
on page 539.
3. Designate a preferred primary and preferred backup using
"Configuring Active/Passive Failover
(CLI)"
on page 562 beginning with step 3.
4. Open the Equalizer Graphical User Interface (or GUI) and click on the
System
configuration
tab if it has not already been selected.Click on the arrows (
u
) beside
Network
to continuously
expand the branch until the subnet of the "Preferred Primary" is visible. Click on the subnet
to display the subnet
Configuration
screen.
5. Click on the
Failover
tab to display the following. In the example shown below a subnet
sn01
for the VLAN
172net
is displayed.
Copyright © 2014 Coyote Point Systems, A Subsidiary of Fortinet, Inc.
All Rights Reserved. 559
Equalizer Administration Guide