ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
INTENDED FOR RESIDENTIAL USE ONLY.
TGS64SD
PAGE 1 OF 2
COURTYARD CREATIONS INC.
STOP
DON’T RETURN TO STORE!
PARTS LIST
PART
NO.
MATERIAL CODE
PART
Q’TY
PART
NO.
MATERIAL CODE
PART
Q’TY
1
1
2
3
4
6
5
7
8
9
10
4
2
2
1
8
1
6
TGS64SD-CS05-1
TGS64SD-CS04-1
TGS64SD-CS04-2
62TGS64SDY101
17C17A0403001YX
17C40A0709001YX
17C40A0705001YX
17KAA0101----Y4
LEG
SUPPORT
CENTER
CONNECTOR WITH RING
SCREW ST4.2*12
BOLT M6*15
BOLT M6*25
HEX. KEY WRENCH 4MM
FIGURE 1
You will need the following tools:
- Phillips Screwdriver (Not Included)
- Hex. Key Wrench (See Part #9)
- Hex. Key Wrench (See Part #10)
Step 1:
Place the table top (#1) onto a non-abrasive surface,
such as a carpet, with its underside facing upwards.
Insert the legs (#2) and the supports (#3) into the plastic
holders attached on the underside of the table top (#1)
rim. Fasten them together by using screws (#5).
See Figure 1.
Attention:
Make sure that each bolt needed for all steps matches
the corresponding figure to ensure proper assembly.
2
Use the correct bolts as indicated. Do not tighten any of the bolts until the table is completely assembled.
Do not sit or stand on this table.
A weighted umbrella base must be used when using an umbrella with this table.
Do not discard of any of the packaging until you have checked that you have all of the parts
and fittings required.
Keep children away during assembly. This item contains small parts that can be swallowed
by children. Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
Quote the following FQC NO. when contacting the service center.
!
!
!
!
!
!
!
SERVICE CENTER TOLL FREE NO.
TEL: 1-877-539-7436
FAX: 1-877-539-7439
5
2
2
2
3
1
3
1
HEX. KEY WRENCH 10MM
17KAC3101----Y3
V-3
TABLE TOP
10
17FC05020601-YX
WASHER d6.5*D10*1.6
