TGS42FG-
WM
PARTS LIST
PART
NO.
MATERIAL CODE
Q’TY
PART
Use the correct bolts as indicated. Do not tighten any of the bolts until is completely assembled.
Do not sit or stand on this table.
A weighted umbrella base must be used when using an umbrella with this table.
Do not discard of any of the packaging until you have checked that you have all of the parts and fittings
required.
Keep children away during assembly. This item contains small parts that can be swallowed by children.
Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
Quote the following FQC NO. when contacting the service center.
SERVICE CENTER TOLL FREE NO.
TEL: 1-877-539-7436
FAX: 1-877-539-7439
COURTYARD CREATIONS INC.
1
2
3
4
5
8
1
4
1
4
1
7
6
8
9
10
11
1
1
16
8
8
Step 1:
Place the table top (#1) onto a non-abrasive surface,
such as a carpet, with its underside facing upwards.
Insert the legs (#2) into the plastic holders on the
underside of the table top (#1) rim. Fasten them together
by using screws (#5). See Figure 1.
ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
INTENDED FOR RESIDENTIAL USE ONLY.
PAGE 1 OF 2
TGS42FG-CS01
TGS42FG-CS02
62TGS42FGY101
62TGS42FGY102
17C17A0403001Y4
17C01A0719072Y4
17KAB1101----Y4
17KAA0201----Y4
18000337002
18000C23001
17FA05040301-Y4
TABLE TOP
LEG
CENTER
CONNECTOR
CENTER
CONNECTOR WITH RING
SCREW ST4.2*12
BOLT M6*55
NUT WRENCH 10&13MM
HEX.KEY WRENCH 6MM
BOLT CAP M6
PLASTIC NUT M6*P1.0
WASHER d6.5*D13*1.0
FIGURE 1
2
2
2
5
2
1
STOP
DON’T RETURN TO STORE!
!
!
!
!
!
!
!
You will need the following tools:
- Phillips Screwdriver (Not Included)
- Hex. Key Wrench (See Part #10)
- Nut Wrench (See Part #11)
