FIGURE 1
PAGE 1 OF 2
V-4
COURTYARD CREATIONS INC.
Step 1:
Place the table top (#1) onto a non-abrasive surface,
such as a carpet, with its underside facing upwards.
Insert the legs (#2) into the plastic holders attached on
the underside of the table top (#1) rim. Fasten them
together by using screws (#5). See Figure 1.
ASSEMBLY INSTRUCTIONS
TGS38HK
PARTS LIST
You will need the following tools:
- Phillips Screwdriver (Not included)
- Nut Wrench (See Part #11)
- Hex. Key Wrench (See Part #10)
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
INTENDED FOR RESIDENTIAL USE ONLY.
SERVICE CENTER TOLL FREE NO.
TEL: 1-877-539-7436
FAX: 1-877-539-7439
Use the correct bolts as indicated. Do not tighten any of the bolts until the table is completely assembled.
Do not sit or stand on this table.
A weighted umbrella base must be used when using an umbrella with this table.
Do not discard of any of the packaging until you have checked that you have all of the parts and fittings required.
Keep children away during assembly. This item contains small parts that can be swallowed by children.
Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
Quote the following FQC NO. when contacting the service center.
!
!
!
!
!
!
!
Attention:
Make sure that each bolt needed for all steps matches
the corresponding figure to ensure proper assembly.
NUT WRENCH 10&13MM
HEX. KEY WRENCH 4MM
PLASTIC NUT M6*P1.0
WASHER d6.5*D13*1.0
BOLT M6*60
BOLT M6*40
SCREW ST4.2*12
U-SHAPED WASHER
CENTER
CONNECTOR WITH RING
LEG
TABLE TOP
17KAB1101----Y4
17KAA0101----Y4
18000C23001
17FA05040301-YX
17C40A0721001YX
17C40A0714001YX
17C17A0403001YX
27LA09076
62TGS38HKY101
TGS34HW-CS04-1
TGS38HK-CS05-1
1
1
8
8
4
11
10
9
8
7
4
4
4
1
6
1
4
5
4
2
3
Q’TY
1
PART
MATERIAL CODE
PART
NO.
STOP
DO NOT RETURN TO THE STORE!
2
2
1
5
2
2
