ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
INTENDED FOR RESIDENTIAL USE ONLY.
TGS37SW
-WM
PAGE 1 OF 2
COURTYARD CREATIONS INC.
STOP DON’T RETURN TO STORE!
SERVICE CENTER TOLL FREE NO.
TEL: 1-877-539-7436
FAX: 1-877-539-7439
1
4
4
4
4
1
1
4
8
7
6
5
4
3
2
1
HEX. KEY WRENCH 4MM
WASHER d6.5*D13*1.0
BOLT M6*25
LEG
TABLE TOP
17C17A0403001Y4
17KAA0101----Y4
18000337004
17FA05040301-Y4
17C33A0709001Y4
Q’TY
Q’TY
PART
PART
MATERIAL CODE
MATERIAL CODE
PART
NO.
PART
NO.
PARTS LIST
SCREW ST4.2*12
BOLT CAP
CENTER CONNECTOR
TGS37SW-CS01
TGS38SW-CS02
62TGS37SWY101
FIGURE 1
4
2
2
2
2
1
You will need the following tools:
- Phillips Screwdriver (Not included)
- Hex. Key Wrench (See Part #8)
Step 1:
Place the table top (#1) onto a non-abrasive surface,
such as a carpet, with its underside facing upwards.
Insert the legs (#2) into the plastic holders attached on
the underside of the table top (#1) rim. Fasten them
together by using screws (#4). See Figure 1.
Use the correct bolts as indicated. Do not tighten any of the bolts until is completely assembled.
Do not sit or stand on this table.
Do not discard of any of the packaging until you have checked that you have all of the parts and
fittings required.
Keep children away during assembly. This item contains small parts that can be swallowed by
children. Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
Quote the following FQC NO. when contacting the service center.
!
!
!
!
!
!
