Warranty and information of the manufacturer
For further information of the warranty terms, please read the information of
“Guarantee Terms and conditions for COUGAR Power Supply Units (PSU) of the
VTE X2-Series”.
This product is not to be disposed in the regular household waste and must be
brought to a collection-point for electrical and electronic devices for recycling. The
symbol to the left refers to that and can be found on the product, in the manual or on
the packaging. Materials can be recycled according to their description. With the
reuse, the recycling or other forms of reutilization of old devices you make an
important contribution to the protection of our environment. Please inquire the
appropriate location of disposal from your local administration.
Trouble shooting
WARNING:
Never work on the PSU yourself. Even long time after its deactivation,
life-threatening voltages can still be present in the PSU. Repairs should only be made
by authorized specialists.
Working at power sources can lead to life-threatening injuries. If there is smoke,
cable damage or intrusion of liquids the PSU has to be immediately disconnected
from the power network and must not to be put into operation anymore afterwards.
Never open the PSU. It contains components, which can show high voltages even
after long periods of deactivation.
Again, repairs should only be done by authorized specialists!
Problem: After the installation of the new PSU the system does not start.
Possible solutions:
●
Check the power code and the power supply of the wall socket and/or multiple
socket strip. Also check whether the multiple socket strip can supply the
necessary power.
●
Check all connections within the PC; maybe not all cables are correctly connected.
●
Check the internal cable of the I/O-switch of the PC case to the mainboard.
●
Check the components for possible short-circuits or defects.
Please also check the other components for compatibility. Often mainboard chipsets
are not compatible with all memory and/or graphics card solutions. Contact the
manufacturer of the component to get more information.
If your PSU still does not function even though you have checked sources of errors
mentioned above, please get in touch with our customer service.
Introduction
Dear customer:
Thank you for choosing a COUGAR
®
power supply unit. Before the installation
please read the manual below carefully. If you have any questions, please contact
our customer service:
Warnings and safety notes
Never open the PSU cover. There is potential danger of life due to high voltage inside.
The PSU should only be opened by an authorized technician. The manufacture
warranty will be void, if the PSU is opened by an unauthorized person.
Do not work on the PSU or the PC as long as the main voltage is still connected.
Switch the I/O button to position "0" and disconnect the power plug from the power
network.
Protect the PSU against moisture.
The PSU is suitable for operation at 100-240V 50-60Hz.
The ambient temperature should not exceed 50°. Please pay attention to the power
de-rating on all models with a decrease of 1%/°C starting at an ambient temperature
of 25°C. Please ensure that there is sufficient ventilation of the entire system.
Make sure during the installation of the PSU that the ventilation slots are not covered.
Do not clog the ventilation slots of the PSU. Keep your PC away from direct heat
sources such as radiators.
When using an extension cord and/or multiple sockets pay attention to the maximum
through-connection ability in order to avoid short-circuits.
If you want to clean your PSU, disconnect the power plug from the power network
and remove it from the PC case. Before the removal make sure that you are not
statically charged, (e.g. through carpets or wool sweaters).Only clean the PSU on the
outside, always using dry cloth, never water or detergent.
During the operation of the PSU pay attention to the maximum loads. The single
loads and the total loads must not exceed to cross the values shown in output power
table. Avoid the use of adapters, such as 4Pin Molex to 6+2Pin PCI-Express.
Technical details and special features
●
EXTREMELY HIGH EFFICIENCY
Up to 88% of efficiency.
●
COMPATIBLE WITH THE LATEST PC-TECHNOLOGY
Created for use with current and next-generation multi-core CPU platforms.
●
SUPPORT MULTI-GPU TECHNOLOGY
Supports PCI Express 4.0 next-generation graphics cards with 8(6+2) pin
PCI-E connector.
●
MASSIVE 12V DC OUTPUT
Extreme Performance for Powerful Graphics Systems.
●
INTEGRATED AIR INLET DESIGN
Optimal aerodynamic design that provides more silent operation.
●
ACTIVE POWER FACTOR CORRECTION (ACTIVE PFC)
PF value up to 99% : Clean and reliable power.
●
FULL PROTECTIONS WITH SCP, OVP, UVP, OPP & OCP
Installation/accessories
Before you begin with the installation, please read the section
”Warnings and safety notes.”For the arrangement only use the supplied screws since
these have the correct thread. You need a screwdriver for the correct arrangement.
The following parts are included within the delivery:
●
Screws for the PSU assembly
●
Power cord (Please only use the power cord which is included; low-quality cords can
damage your PSU and your PC-system.)
●
Brief instruction incl. Information about the warranty
●
Place the PSU into its designated place within the case and fix it with the supplied screws.
●
First insert the plugs for the mainboard supply (20/24 pin, 4 pin and possibly
8 pin – according to mainboard layout) into the respective slots.
●
Connect the disk drives and if necessary the graphics cards to the PSU.
●
Close the PC and ensure that the PSU power switch is set to the position "0".
●
Connect the PSU to the power network using the supplied power cord. Using only
the power cord provided in the package. Low quality power cord may damage the
PSU and PC system!
●
Turn on the PSU and then start your PC.
Safety functions
●
UVP (Undervoltage protection)
If the voltages fall below a certain tolerance value on the single lines, the PSU
automatically switches off.
●
OVP (Overvoltage protection)
If the voltages increase above a certain tolerance value on the single lines, the PSU
automatically switches off.
●
SCP (Short-circuit protection)
In the case of a short-circuit this feature prevents damage to the core components
of the PSU and its system components.
●
OPP (Overload protection)
If the system is oversized and requires more power from the PSU than it can
perform, this protection function is activated.
●
OCP (Overcurrent protection)
If the current on a single line is higher than indicated,the PSU automatically switches off.
Specifications
●
Operating conditions
Working temperature: +10°C ~ +40°C
(Please note the de-rating condition in Warnings and safety notes)
Storage temperature: -40°C~+70°C
Operating humidity (without condensation water): 20%~85% relative humidity
Storage humidity (without condensation water): 5%~95% relative humidity
V TE X2
600/650/700/750
●
Output power
●
Connectors
Main
CPU
24(20+4) Pin
8(4+4) Pin
Peripheral
S-ATA
PCI-E
Pin
Connector
5 Pin
8(6+2) Pin
4 Pin
1
2
6
2
1
VTE X2 600
1
2
6
2
1
VTE X2 650
1
3
8
4
1
VTE X2 700
1
3
8
4
1
VTE X2 750
+3.3V
20A
130W
600W
0.3A
3A
3.6W
15W
3.6W
15W
3.6W
15W
600W
20A
50A
+5V
+12V
Total
100-240V~
50-60Hz
12A
100-240V~
50-60Hz
15A
-12V
+5Vsb
AC input
Model Name
DC output
130W
649.2W
0.3A
3A
650W
20A
20A
54.1A
140W
699.6W
0.3A
3A
650W
22A
22A
58.3A
VTE X2
600
CGR VX-600
3.6W
15W
140W
750W
0.3A
3A
750W
22A
22A
62.5A
VTE X2
650
CGR VX-650
VTE X2
700
CGR VX-700
VTE X2
750
CGR VX-750