Part 3 - Configuration
61
Advanced Setup
Configure security and other advanced camera settings.
•
Video
: Adjust the camera image sensor settings such
as white balance and exposure. Configuration options
may differ depending on the camera model.
•
Privacy Masking
: Enable/disable and configure
privacy masking for the camera.
•
SSL
: Set the camera's security level as
Unavailable
,
Standard
,
High
, or
Very High
.
Standard
,
High
and
Very High
settings apply SSL (Secure Sockets Layer)
protection to the camera.
•
Power
: Control the camera's power. This option is
available when connecting to Video In/PoE port or
using a PoE Switch (optional). Select
Reset
in the
camera’s power settings to restart the camera. It is not
supported by video encoders.
•
Mode
: Select a resolution mode. It is supported by
analog cameras only.
•
PTZ
: If using an RS485-compliant camera, configure it
for use in PTZ Mode.
–
PTZ Product
: Choose to select the model of
installed PTZ device.
–
ID
: Choose to assign an ID to each PTZ device.
– Choose to set up
Baud Rate
,
Data Bit
,
Stop Bit
and
Parity
of the connected device.
Refer to the PTZ device manufacturer’s instructions for
the proper settings.
Types of configuration options shown vary depending
on the PTZ functions supported by the camera.
1
2
3
4
5
6
7
8
9
0
Numbers shown below Preset, Scan, Pattern,
and Tour indicate the numbers of configured
functions.
1
Preset
• Use the buttons below to choose a preset
position.
- Directional Buttons
(
):
Used to tilt and pan the camera.
-
Zoom
(
): Zoom in and out.
-
Focus
(
): Adjust camera focus to far or
near.
-
Speed
: Specify the camera's panning and tilting
speed.
