Cosatto YOGA, Instructions Manual

Page: 3 / 16

operation
1 - list of parts
Your pushchair is supplied in one carton and contains:
1. Chassis
5. Rear wheel cover x2
2. Chest Pads (Supplied fitted to harness) 6. Front wheel assembly
3. Rear axle assembly 7. Bumper bar
4. Rear Wheel x2 8. Raincover
2 - unfolding the chassis
Lift the handle upwards (a) until the chassis automatically locks into position (b). It is recommended
that you check the chassis is locked before continuing.
3 - fitting the rear axle assembly
Turn the chassis upside down. Insert the axle assembly into the chassis legs as shown (a). Push the
axle assembly down until the plastic pins lock in place (b).
4 - fitting the rear wheels
Remove the R clip and one washer from one side of the axle (a). Fit the wheel on to the axle shaft (b).
Place the washer on to the axle (c) and secure the wheel with the R clip (d). Finally fit the cover (e).
Repeat this procedure with the other rear wheel.
5 - fitting the front wheel
Align the wheel assembly with the chassis leg as shown (a). Push the the assembly on to the leg
until the spring loaded pin locks it in position (b).
When all the wheels are fitted, turn the chassis over to the upright position.
6 - using the brake
The brake levers are located on either side of the axle assembly. Press down on one of the levers (a)
to lock the rear wheels. It is recommended that you test the brake is engaged by trying to push the
pushchair for a short distance.
Lift one of the brake levers (b) to release the brake.
7 - front swivel wheel
To lock the swivel wheel, turn the wheel assembly until the lever is facing forward, then lift the
lever up (a).
To release the swivel wheel, push the lever down (b).
8 - fitting the bumper bar
The detachable bumper bar allows easy access to the seat. Before fitting bumper bar please ensure
that the brake is applied. Fit the ends of the bumper bar to the locating pins on the chassis (a)
until it locks in place.
Press the buttons (b) under the ends, on each side, to remove the bumper bar.
9 - using the hood
To raise the hood pull it forward (a). To lower the hood push it back.
To raise the sun visor pull it forward (b). To lower the sun visor push it back.
The window cover on top of the hood can be opened by pulling it up from it’s velcro
®
fastening.
Roll the cover up and secure to the rib of the hood with the elastic toggle (c).