Cosatto Wowee ABCS, Instruction

Page: 6 / 36

3
EN
Fitting & operation information:
Please refer to the
instruction diagrams (P. 27 - 30)
:
Carrycot Preparation:
1-
Empty the content from carrycot (a).
Unfold both frame bars until they locked into positions (b).
2-
Noting the position of the head end (a), fit the liner into the carrycot and secure
(b).
Fit the mattress over the liner in the carrycot (c).
There are a set of “D” ring located at the base of the carrycot for the attachment
of a separate safety harness approved to BS EN 13210 should this be required
(harness not supplied). Push the “D” rings through the slots in the liner (d).
3- Open the hood bar (a).
4-
Secure the hood fabric to the hood bar (a) and the carrycot frame (b).
Apron 5- Fitting:
Removing is a reversal of this procedure.
Hood 6- Using the sun visor:
7- Using the ventilation panel:
8- Closing:
Adaptor 9- Fitting:
Dots are marked on the adaptors and chassis mounts (a).
These should be on the same side and aligned if fitted correctly.
10- Removing:
11-
Note: The carrycot can only be fitted rearward facing as shown in illustration.
Pram mode 12- Fitting:
Dots are marked on the carrycot mounts and adaptors (a).
These should be on the same side and aligned if fitted correctly.
13- Removing:
Press the memory release button (a). The button will stay depressed.
Press and hold the release button on the opposite side of the carrycot (b).
Lift the carrycot off the chassis (c).
Note: Please ensure that the hood bar is locked securely before lifting the
carrycot clear of the chassis.
Raincover 14- Fitting:
Removing is a reversal of this procedure.
15- Using the access zip:
16- Accessing the handle: