Cosatto TO & FRO, Instructions Manual

Page: 5 / 57

9 - fitting the softgoods - parent facing mode
NOTE: Before fitting the footmuff check that the support wedge is fitted (a).
Remove the chest pads by releasing the fabric fastener along the length of the chest pad (b).
Unfasten the harness buckle then separate the shoulder strap clips and waist strap clips (See step 6).
Pass the harness straps through the slots in the footmuff and seat liner (c, d & e) then attach the
fasteners to the back of the seat (f).
Fit the headhugger, ensuring that the shoulder straps fit above the headhugger slots (g).
Refit the chest pads to the shoulder straps.
Removing the footmuff and headhugger is the reverse of this.
NOTE:
Please note the seat liner, fitted with the support wedge, must be used in parent
facing mode.
10 - using the back support - parent facing mode
In parent facing mode, there are 3 back support positions. The most reclined position in parent
facing mode is recommended for new born babies until ready to progress to more upright
position. (e.g. this may be when they can sit up unaided.)
Before adjusting the back support release the seat retaining flap at the rear of the backrest (a).
Press the buttons on both sides of the back support (b) and adjust the angle of the back support (c).
Release buttons (d) to lock the back support in position.
When the back support is in the desired position refasten the seat retaining flap to complete the process.
11 - using the basket - parent facing mode
Zip fasteners (a) on each side of the basket allow access to the basket when in parent facing mode.
12 - fitting the hoods - parent facing mode
The supplied hood can be used for both parent and forward facing modes. The hood is pre-set for
fitting in parent facing mode.
Noting the arrow on hood mount indicating the correcting alignment of the hood. In parent
facing mode the arrows should point towards the hood (a).
Slide the hood mounts on to the fixing brackets on both sides (b) and the centre of the chassis (c).
On each hood, connect the fastener strips (d) on the outward facing side and fasten the zip on the
inward facing side (e).
Stretch the back of the hoods over the backrests (f) ensuring the backrest adjuster buttons are
covered (g).
Fasten the elastic strap under the backrests (h).
Removing the hood is a reversal of this procedure.
13 - using the hoods - parent facing mode
To raise a hood, push the top of the hood towards the pushchair handles (a).
To retract the hood, pull the hood back (b).
To raise the sunvisor, pull the sunvisor forward (c).
To retract the sunvisor, push it down & back into the hood (d).
14 - folding the chassis - parent facing mode
NOTE: If the hood is fitted, retract the hood completely before folding (a).
Raise the backrest (b).
To fold your pushchair lift the handles (c) and at the same time press down on the secondary lock (d).
Keeping the secondary lock pressed down, push the handles forward until the chassis is folded in
half. Continue pushing until the autocatches engage (e).
NOTE:
Take care not to damage the stand mechanism when folding. Pressing down too
hard on the chassis can bend the stand arms (f).