Cosatto nitty gritty WOOP, Instruction Manual

Page: 5 / 44

13 - using the harness
A five point harness is provided to restrain your child. To unfasten push the button on the buckle
(a) and pull the clips clear.
To fasten the harness push the shoulder strap clips onto the waist strap clips (b) then push the
waist strap clips into the buckle until they lock in place (c).
Sliding adjusters are fitted on the shoulder straps, waist straps and crotch strap (d). The harness
should be carefully adjusted so that it fits your child comfortably. To adjust to the smallest size on
the waist strap you will need to thread the adjusters through the “D” ring.
To adjust the shoulder strap height, unzip the liner on the back of the seat, locate the strap ends
(e) and pass through the slots, reposition to the desired height and pass the strap ends back
through relevant slot.
To remove the harness unzip the liner on the back of the seat, locate the strap ends (e) and
pass through the slots. Under the seat, pass the crotch strap end through its slot (f). On each side
of the seat feed the edge of the webbing through the opening in the ‘C’ clip (g). Push the ‘C’ clip
through the ‘D’ clip. The harness can now be removed from the seat.
Refitting the harness is a reversal of this procedure.
‘D’ rings are fitted at the end of each waist strap should you wish to attach a separate harness
complying to BS EN 13210.
To remove or fit the chest pads unclip the buckle and remove the shoulder strap clips from the
waist strap clips and slide the chest pads on or off the straps.
WARNING: Always use the crotch strap in combination with the
waist belt.
14 - fitting the footmuff
Unfasten the waist strap clips and shoulder strap clips. (See step 20.) Remove both chest pad and
crotch pad from the seat unit (a).
Unzip the footmuff cover and remove (b) Place the footmuff over the seat. Feed the harness straps
through the harness slots on the footmuff (c, d & e).
Push the fastener tabs (f) through the slots on each side of the backrest and fasten at the back (g).
Fit the headhugger, ensuring that the shoulder straps fit above the headhugger slots (h).
Refit the crotch pad, chest pads and footmuff cover.
To remove the footmuff reverse the procedure above.
In from birth mode, it is recommended to thread the bumper bar through the hand warmer on footmuff (i).
The two halves of the footmuff are reversible.
15 - fitting the seat hood
Place the hood on to the seat frame as shown.
Place the top of the hood mounts (a) over the chassis frame and then push hard on the bottom (b)
until the hood mounts clips in place. Attach the fasteners (c) on both sides.
To remove the hood pull the lip at the bottom of the hood mount away from chassis on both sides (d).
16 - opening and closing the seat hood
Pull the hood up to open (a). Push the hood back to close (b).
To retract the sunvisor push down in the centre (c) until the sunvisor folds back inside the hood.
To raise the sunvisor pull the sunvisor forwards and up (d) until it locks in place.
17 - fitting the raincover (from birth mode)
Fasten the zip at the bottom of the raincover (a).
Starting from the foot end of the seat unit (b & c), fit the raincoover over the seat unit as shown.
Fasten the zip (d) at the rear of the raincover to secure the raincover.
There is zip located at the front of the raincover (e) for access to your child.