Cosatto nitty gritty WOOP, Instruction Manual

Page: 3 / 44

•
Do not allow your child to climb unassisted into, play with or hang onto your pushchair.
•
Always apply the brakes when the pushchair is stationary. Hold on to your pushchair when close
to moving road vehicles or trains. Even with the brake on the draught from the vehicle may move
the pushchair.
•
Exercise caution when mounting or dismounting a kerb. Remove your child and fold the
pushchair when ascending or descending stairs or escalators.
•
Ensure the folded pushchair is stored away from children so that it does not fall and cause injury.
•
Never carry a second child on the product.
•
This product complies with BS EN 1888:2012.
car seat (sold separately)
•
When car seat is used in conjunction with the chassis, this product does not replace a cot or a
bed. Should your child need to sleep, then it should be placed in suitable cot, bed or carrycot.
list of parts
Your pushchair is supplied in one carton.
1. Pushchair chassis
7. Bumper bar with cover
2. Rear wheel x2 8. Headhugger
3. Front wheel assembly 9. Changing bag
4. Seat unit hood 10 Raincover
5. Seat unit (chest pad & crotch pad fitted) 11. Car seat mounting adaptors
6. Footmuff
1 - opening the chassis
Press the buttons (a) on either side of the chassis and push the handle down (b). Release the
locking lever (c) and lift the handle upwards until the chassis locks in the open position (d).
WARNING: Ensure that all locking devices are engaged before use.
The height of the handle can be adjusted by pressing the buttons (e) on either side of the chassis
and lifting the handle up (f) or down (g) to the preferred position.
2 - fitting the front wheel assembly
To fit the front wheel assembly insert the pin at the top of the wheel assembly into the wheel
housing (a) until it locks in place.
To remove the wheel assembly, pull back the lever located at the back of the wheel housing (b)
and remove the wheel assembly from the housing.
3 - fitting the rear wheels
To fit a rear wheel insert the pin into the wheel housing (a) until it locks in place. Repeat this with
the other rear wheel.
To remove the rear wheels, press the buttons on top of the wheel housings (b) and pull the wheels
clear (c).
4 - using the parking brake
To apply the brake, press the lever down firmly with your toe (a). Test the brake is engaged
correctly by trying to push the pushchair forwards for a short distance. To release the brake, lift the
lever (b).
NOTE:
Always ensure that the brake is engaged when placing and removing the child from the
pushchair.