Cosatto HUG, User Manual

Page: 10 / 95

21 - installing the child car seat in Group 2/ 3 mode, without
ISOFIX (15 to 36kg, approx. 4 to 12 years old) - 3
Place your child in the child car seat and fasten the vehicle seat belt.
Pull the vehicle seat belt upwards to tension the belt (a).
The vehicle seat belt should be positioned between your child’s shoulder and neck (b).
If the vehicle seat belt is in the correct position the lap belt should fit over the red tags
sewn into the cover on either side of the seat (c). The height of the vehicle seatbelt can
be adjusted by squeezing the lever at the back of the headrest and raising or lowering
the headrest to the correct position (d).
IMPORTANT: The position of the seat belt/lap strap buckle can
affect the stability of the child car seat. In an accident this could
stop the child car seat from protecting your child as well as it
should. If, when the seat belt/lap strap belt is properly tightened,
the buckle lies in the position marked then try fitting the child
car seat in another seating
position in your vehicle.
For the safety of the child please check:
•
The diagonal belt section runs through the seat belt guide located on the headrest
and the lap belt must pass over the red tags sewn into the seat cover.
•
The straps are tightened and not twisted.
•
The vehicle seat belt buckle is correctly located on the side of the car seat and is not
obstructed.
IMPORTANT:
The shoulder belt must cling to the child’s shoulder
and chest. The lap belt must pass over the red tags sewn into the
seat cover. Always make sure that your vehicle seat belts are
correctly tensioned to ensure maximum protection for your child.
22 - removing the covers for cleaning
Remove the harness and seat liners if fitted. See steps 12 to 15.
Headrest: Lift the headrest to the highest position (a). Starting on one side carefully pull
the cover off (b).
Release the belt lock under the headrest (c) and pull the elastic loop through the gap (d).
Release the elastic loop (e). Repeat this procedure on the other side of the headrest and
remove the headrest cover.
Seat:
Starting on one side carefully pull the cover off the seat (f). At the rear of the
backrest lift the elastic strap over the headrest (g). Push the harness adjuster strap
through the elastic loop under the harness adjuster flap (h) then pull the cover from
around the adjuster button (i). Unclip the six elastic loops holding the cover to the seat
(j) and remove the cover.