Cosatto GIGGLE 2, Instruction Manual

Page: 6 / 132

Raincover 22- Fitting:
Removing is a reversal of this procedure.
Seat unit 23- Fitting:
Note: The seat unit can be fitted forward or rearward facing.
24- Removing:
25- Adjusting seat unit recline angle:
WARNING: Never adjust the seat unit with your child
in the seat.
Harness 26- Opening:
27- Closing:
28- Adjusting the strap length:
Slide the strap adjustor to suitable length (1, 2 & 3).
29- Adjusting the shoulder strap position:
30- Removing:
Push the shoulder strap retainer through the backrest (1).
Push the crotch strap retainer through the seat (2).
Rotate the “C” clip to expose its opening (3) and slide the waist strap out of the clip (4).
Refitting is a reversal of this procedure.
Bumper bar 31- Fitting:
32- Opening:
33- Removing:
Footmuff 34- Fitting:
Open the harness 26 and remove chest pad & crotch pad (1).
Push the harness straps through the footmuff (2).
Attach the footmuff fabric fasteners to the rear of the backrest (3).
Refit chest pads & crotch pad then close the harness 27 .
Seat unit hood 35- Fitting:
36- Adjusting:
37- Removing:
Raincover 38- Fitting:
Child car seat
adaptor
39- Fitting:
Note: The child car seat adaptors are supplied with the “Giggle 2” TS.
The adaptors are handed. Dots are marked on the seat mounts and the adaptors (1).
These should be on the same side if fitted correctly.
40- Removing:
Car seat mode 41- Note: The child car seat should only be fitted rearward facing.
42- Fitting:
43- Removing:
Press the memory release button (1). The button will stay depressed.
Press and hold the release button on the opposite side of the car seat (2).
Lift the child car seat off the chassis (3).