Cosatto CC TWIN, Instructions Manual

Page: 3 / 12

operation
1 - list of parts
1. Pushchair (basket attached) 4. Footmuff X 2
2. Raincover 5. Chest pad X 2 sets
3. Hood
2 - how to open your pushchair
To open the pushchair, first release the two catches (a) on each side of the pushchair which holds
it in the umbrella position. Now holding the pushchair by the handles, gently lower the front.
To complete the operation: press hard on the rubber pegs (b), until you hear the ‘click’ of the
secondary locking bar (c).
WARNING: Ensure that all locking devices are engaged before use.
3 - using the hood
To fit the hood, clip the brackets (a) over the handle tubes as shown. Reverse the above procedure
to remove the hood. To use the hood push the two side levers on the side of the hood down.
To fold the hood back, lift the two side levers (b) up and push the hood back.
4 - fitting the raincover
With the hood fully opened, place the split, shorter section of the raincover over the hood so that
it hangs at the rear of the pushchair. The middle handle fits through the hole in the cover (a).
At the front wrap the straps around the chassis and fasten the press studs (b). At the back secure
using the velcro ® tabs in the bottom corners (c).
5 - using the harness
A five point harness is provided to restrain your child. To fasten the harness push clips into
buckle. To unfasten push clips in and remove from buckle.
Sliding adjusters are fitted on the waist strap and should be carefully adjusted so the harness
fits your child comfortably. To adjust to the smallest size you will need to thread the adjusters
through the “D” ring.
‘D’ rings are fitted at the end of each waist strap should you wish to attach a separate harness
complying to BS EN 13210.
The length of each strap can be changed by using adjusters (a), (b) & (c).
WARNING: Always use the crotch strap in combination with the waist belt.
6 - fitting the footmuff
To fit the footmuff unfasten the harness and pass the harness straps through the slots in the back.
Attach the velcro® straps at the top of the footmuff to the back of the seat. Slide the chest pads
onto the shoulder straps.
To remove the footmuff reverse the above procedure.
7 - using the brake
To apply the brake, press either of the brake levers firmly with your toe (a). Test the brake is
engaged by trying to run the pushchair forward for a short distance. To release the brake, raise
either of the levers (b).
NOTE: Always apply brake before loading or unloading of the children from the pushchair.
8 - using the backrest
The backrest can be adjusted in four different positions. To lower the backrest, simply lift the
two levers at right and left and the backrest will drop down automatically. To raise, push the
backrest upwards from the centre to the required angle: it will lock into place automatically.
9 - using the swivel wheels
To allow the wheels to swivel, push down on the locking lever as shown (a). To lock the wheels
into position lift the locking lever up (b) with the wheels in any position and run the pushchair
until you hear each wheel ‘click’ as they lock in position.