HomeVision® Pro
© Corroventa Avfuktning AB
2021.02
38 (44)
Remove unit
In status view, normal view, first press
<Setup>
and
then <
▼
> twice to get to the Settings view.
In the settings view, press
<Select>
and then
<
▼
> so that the ”Remove unit” row is marked. Press
<OK>
to select this function.
The panel now asks the user to select the unit to be
reset. If required, press <
▼
> to scroll to the relevant
unit. If the relevant unit is already marked, press
<OK>
to continue.
To prevent any unintentional changes, the user
confirms the selection and intention once more.
Press
<OK>
if everything is OK.
The unit has now been removed from the system. Its
data will no longer be presented on the control panel
and nothing will be logged from it. Neither will any
alarms be presented. The control module will
however continue to control its dehumidifier in
accordance with the settings it has, as long as it is
not disconnected.
The unit name that the removed unit had, for
example A1, is now available again. If this number is
the lowest available number, this name will be
assigned to the next unit that is connected. In the
event of a hardware replacement, ensure the old
unit is removed before connecting the new one. In
this way the new unit gets the same name as its
predecessor.
