CORRECT CRAFT Air Nautique, User Manual

Page: 153 / 188

8-9
Quick Oil Drain System
Change the engine oil after the first 25 hours of operation, then
after every 50 hours. The boat must be removed from the water to
use the quick oil drain system. There is a drain hose attached to the
bottom of the oil pan with a small plug screwed into the loose end
of the hose. Remove the drain plug (T-handle) (A), located in the
bilge area, and put the end of the drain hose through the drain
hole.
Make sure there are no kinks or sharp bends in the hose. Remove
the plug at the end of the hose and drain the oil into a container
under the boat. The engine will drain most efficiently when the oil
is warm. Allow several minutes for the oil to settle and drain.
Dispose of used oil in an environmentally safe manner.
NOTICE
Be sure the engine is off when you are draining your oil.
Salt Water Boating
NOTICE
If you use your boat in salt water or other unusual water
conditions, fresh water flush your engine and cooling system with
freshwater.
Correct Craft offers an optional fresh water flush kit. The relief
valve in this kit prevents excessive water pressure to your engine. We
recommend using this system if you use your boat in salt water or
unusual water conditions. Flushing the system by running the boat
in fresh water is another good way to flush the engine, but it must
be done immediately.
Care and Maintenance
Sport
Used engine oil can be harmful. Avoid
prolong or repeated contact with skin. Wash affected
area immediately with soap and water.
!
WARNING
Nautique Sport Sec 8.qxd 7/8/05 4:11 PM Page 8-9