CEILING CUT OUT
RUSH NT
INSTALLATION GUIDE-RECESSED
PART LIST
A-4-40 Screw
B-End Plate
C-Extrusion
D-Optional Support Bracket
E-Lens
F-Connection Bracket
G-8-32 Set Screw
H-Alignment Pin
EXPLODED VIEW
CORONET, Inc.
55 Shepherds Lane
Totowa, NJ 07512
T
973 345 7660
F
973 345 8705
CORONET, Inc. reserves the right to make any design changes for continuous improvement which will not
affect the overall appearance or performance. All fixtures to be wired by a certified electrician only.
WWW.CORONETLED.COM
1/2
!
Risk of fire and electrical shock. In accordance with national local building and electrical codes, CORONET lighting fixtures must
be installed by a qualified electrician. Disconnect power at electrical panel before servicing.
CROSS SECTION VIEW
INDIVIDUAL FIXTURES ARE NOT INTENDED FOR CONTINUOUS RUNS.
ADDITIONAL SUPPORTS TO THE STRUCTURE MAY BE REQUIRED.
*CHECK WITH YOUR LOCAL BUILDING CODE FOR THOSE REQUIREMENTS.
SIDE VIEW
PLEASE CONSULT FACTORY SHOP DRAWINGS
FOR CEILING CUT OUT DIMENSIONS
EXPLODED VIEWS ARE TO SHOW DETAIL ONLY, FIXTURES ARE SHIPPED PRE-ASSEMBLED.
For use of the optional support bracket to mount the fixture, block in the fixture
using the ceiling cutout dimensions as a guide. Material/blocking by others.
Note: Leave a hole for the power feed cable.
1 Option 1
A
B
C
D
E
G
F
H
Use a machine screw and nut to secure the support bracket to the frame (hardware
by others).
2
Raise the fixture upward until it snaps into the support bracket.
3
CEILING
BLOCKING
BY OTHERS
