Instruction for use
33
3.6. H
ALTING AND
P
ARKING
The machine is equipped with a hydrostatic system
enabling halt quite simply on releasing the drive levers.
The machine slows down proportionately as a function of
the manner of release. When the levers are fully
released, the machine halts.
If you wish to park, before halting, choose a
position for the machine that is preferably on a
surfaced area which is level, and in any case on
ground which is level, stable and firm:
•
Use the accelerator lever to lower engine revs, with
the engine ticking over at minimum revs;
•
Turn off the engine
3.7. U
SE
P
ARKING
B
RAKE
The machine is equipped with an electrohydraulic
brake. Hence, when the drive levers are in the stable at-
rest position, the multidisk brakes in the reduction units
are automatically enabled by means of an electronically
controlled valve. Therefore, even when its engine is on,
with a full load on a slope, the operator may leave the
machine without running the risk of the machine moving
in his/her absence.
When the engine is turned off, the aforementioned
brake automatically (on this occasion, hydraulically)
enables the disk brakes in the reduction units.
The machine is therefore immobilized where it has
been parked.
3.8. T
RANSPORTING
L
OADS
PROHIBITED: It is strictly prohibited to
surpass the load capacity limits indicated in
the table 1.11.
3.8.1. C
ONSTRUCTION
B
ODY
(D
UMPER
)
The machine is equipped with a “dumper” type body
to transport inert and solid materials, suitable mainly to be
used for construction work.
3.8.2. T
HREE
-
SIDED
3S
TYPE BODY
According to requirements, your machine can be fitted
WARNING: If you move away from the machine
and leave it unattended, always activate the
parking brake and be sure that no unauthorized
persons may turn it on or move it. In the models
which are equipped with one, always take out the
start-up key and unplug the battery.
