Corghi Artiglio Master 28, Operator'S Manual

Page: 53 / 84

Artiglio Master 28
Operator’s manual 135
EN
To increase the effectiveness of the air jets, manually lubricate and lift the lower
bead before activating the nozzles
CAUTION
To improve the operation of the tubeless tyre inflation system the line pressure must
be between 8 and 10 bar.
CAUTION
Continue inflating the tyre using the air hose. Frequently stop inflation and check the
pressure on the pressure gauge.
Risk of explosion. During the bead insertion phase, do not exceed the maximum pressure
indicated by the manufacturer on the sidewall of the tyre.
CAUTION
Once the bead has been inserted, refit the internal part of the valve and then inflate the
tyre to the pressure indicated by the vehicle manufacturer.
Operate the inflation jets only for tyre bead insertion. Do not point jets towards people.
CAUTION
Discharge the air from the pneumatic system before disconnecting the power supply or
other pneumatic components. The air is accumulated in the tank for operating the bead
insertion jets.
Operate the air jets only after making sure that the device is securely in position and
the rim is correctly blocked.
CAUTION
RISK OF EXPLOSION. Do not mount a tyre and a rim that do not have the same diameter
(e.g., 16 and 1/2 inch tyre and a 16 inch rim).
CAUTION
If the tyre is excessively inflated, the air can be released by pressing the brass manual
deflation button located below the air pressure gauge (“2” - Fig.41e)