TigoBridge B1
User Manual
Copyright © 2021 CoreTigo Ltd.
Page
13
of
21
Figure 8: TigoBridge B1 and Cradle
Figure 9: TigoBridge B1 Mounted on the Cradle
Cradle Mounting Guidelines:
1. Secure the cradle on the flange (or machine or any other surface) using M3 screws or cable ties.
2. Mount the TigoBridge B1 onto the cradle by pushing it in.
3. Pull the TigoBridge B1 from the cradle to unmounting it.
6.
Configuration & Setup
Commissioning Prerequisites:
•
TigoEngine software installed and running on PC.
•
TigoMaster/TigoGateway successfully connected to PC.
Installation:
1. Plug a 24VDC power supply to TigoBridge B1 M12 power connector via M12 cable.
2. The Power LED lights up green. If it does not, check the power connection.
3. Once the power supply is connected, a reset cycle occurs. The reset cycle duration is a few
seconds and displays a red green blue color sequence.
4. Once the reset cycle is complete, the status LED alternates between magenta and yellow.
5. Plug the TigoBridge B1 to an IO-Link device (sensor/actuator).
Note
, if TigoBridge B1 cannot connect directly to the device, you may use an M12 cable. Once
successfully connected the Status LED alternates between Magenta and Green.
6. Open the TigoEngine and scan the network for the IO-Link Wireless TigoBridge B1.
