User and Maintenance Manual
Failsafe hydraulic brake ID 2000N
Model ID 2000N-116
Date: 2014/06/27
Revision: 1.1
www.coremo.it
Page
15
of
25
Photo 13
3.
Following this operation, retighten the two safety grub screws (C61579) in order to prevent
possible rotations and movements of the wear adjuster (D71244) during operation of the
brake (Photo 14).
Photo 14
Pay particular attention during this regulation because rotating the gap regulator (D71244)
anticlockwise , this could tighten inside the thruster (D71243) and get definitely stuck.
9.2.
Replacement of the lining pads and cleaning the friction surfaces
1.
Power up the brake and insert the safety hook (C62257) in its seat of the thruster which
protrudes from the cover (Photo 15). Once the hook has been inserted the pressure can be
removed from the brake.
(Remove the brake from the machine only if necessary; in this
case proceed as described from point 1 to point 3 of section 9.3)
1 mm
