NOTE: We recommend the use of Loctite® or similar
thread lock product when assembling parts on your
motorcycle.
1. Start by removing your stock seat.
2. Remove the top side covers using a phillips
screwdriver. (Figure 1a)
3. Remove the bottom side covers by removing the
screw on the top of the cover. Tug the bottom outward
to release it from the rubber grommets, then slide the
cover back and down to unhook it off the fender.
(Figure 1b)
NOTE: You will not be reusing the bottom side covers,
but you will be reusing the screw that secured the side
cover to the sub frame.
4. Next you are going to install the right foot peg
mounting bracket (#A00848).
Part Number:
H-RUNE-BAG & H-RUNE-HDBOX1H
Description:
Saddle Bags & Trunk Box
Fitment:
2005+ Honda Rune
Revision:
1
Tools Required
Parts List
3/32 Hex key (Allen wrench)
Phillips Screwdriver
19mm socket wrench
19mm open wrench
12mm socket wrench
Wire Crimper or Pliers
SADDLE BAGS
1 #A00848 Right foot peg mounting bracket
1 #A00850 Right bag mounting bracket
1 #A00847 Left foot peg mounting bracket
1 #A00849 Left bag mounting bracket
2 8/32 x 1 Phillips Screws
4 10mm x 1.25 x 70mm Hex head bolts
1 #P10472 Stainless steel spacers (long)
1 #P10475 Stainless steel spacers (short)
4 8/32 x ½ Chrome button head Allen screws
1 8mm x 1.25 x 70mm Hex head bolts
1 8mm Split lock washer
1 8mm Flat washer
2 12mm x 1.25 x 60mm Hex head bolts
7 12mm Flat washers
2 12mm Nylock nuts
TRUNK BOX
6 3/8" x 16 Chrome Acorn nuts
1 #A00851 Left Mounting bracket
6 3/8" Split lock washers
1 #A00852 Right Mounting bracket
6 3/8" Flat washers
6 1/4” x 20 x 1½” Chrome button head Allen screws
2 Spade connectors
2 3/8” x 16 x 1½” Chrome button head Allen screws
4 Male spade connectors
2 3/8” x 16 1¾” Chrome button head Allen screws
4 Female spade connectors
6 1/4” x 20 flat washers
2 Side covers
4 3/8” split lock washers
FIG 1
FIG 2
A
B
PLASTIC
CLIP