Please read these instructions carefully before first use and retain for future reference.
Parts
1 x Machine body
8 x Pads
1 x Electrode wire
2 x Pasters
•
The Tens Machine works
through 2 electrodes (1x
positive and 1x negative)
which in turn excite and
placate the nervous system.
It is the move from positive to negative and back again that causes the pulse sensation.
•
The low frequency current transmits electronic stimuli to the body at tiny intervals. The
change in frequency from “tap” to “vibration” to “massage” dictates the sensation
received. This range of frequencies (from 2-100Hz) can relieve some soreness and
aching from muscles.
•
This relief comes encouraging the muscles to contract which increases blood flow and
improves blood circulation to the affected area.
Operation
1. Set strength/power to zero and remove the battery compartment cover and insert 2 x
AAA batteries ensuring the correct polarity is observed. Replace cover.
2. Connect electrode wire to Tens machine and attach pads to cable ends.
3. Put pad onto part of the body requiring treatment using pasters.
4. To turn on, hold down the power button for 2 seconds until the red LED indicator is
illuminated.
5. Select desired setting, intensity and speed.
6. A full treatment last for up to 15 minutes. After this time the unit will automatically
turn off. Once the treatment has finished, set the intensity to the minimum level. To
turn off prior to this hold down the power button for 1 second.
Cleaning
•
Wash pads with cold water after
approximately every 30 uses or as
necessary.
•
Using a damaged or dirty pad may
lead to skin becoming red or sore.
•
Cleaning the pad too frequently
will cause the surface of the pad
to lose tackiness.
Troubleshooting
•
A dim or non-functioning LED light
may signify that batteries need
replacing/recharging.
•
If no pulse can be felt, check the
electrode wires are correctly inserted
into the machine body.
TWIN CHANNEL T.E.N.S
Instructions
8 3 7 0
