Handheld Power Cleaner
10991
Instructions for Use
Please read and retain these instructions for future reference
v001: 04/10/17
This battery operated power cleaner comes with a set of four interchangeable brush heads that rotate to
reduce the need for scrubbing. The set is suitable for general household cleaning and the brush heads are ideal
for reaching difficult to access areas such as crevices, the base of taps and shower tracks.
Spare Heads are available – item code 10993.
Inserting the batteries:
The battery compartment is located on the base/
end of the handle. To remove the cover, press the
two nodules near the bottom of the thermoplastic
rubber grip (one on each side) inwards at the same
time then pull the cover off the battery
compartment.
Insert 4 x AA batteries
(not included)
with polarity as
shown inside the battery compartment cover and in
the diagram on the right. Replace the cover by
pushing it firmly on the base of the handle. The cover
only fits one way onto the handle.
Using the Power Cleaner:
A sliding ON/OFF switch is located on the back of the handle (above the thermoplastic rubber grip).
Slide the switch upwards to turn the unit ON and slide it downwards to turn it OFF.
Ensure the ON/OFF switch is in the OFF position while changing the brush head.
To remove a brush head, hold the handle facing you and rotate the brush head slightly to the right
then pull it upwards and off the shaft at the top of the handle. To attach a brush head, rotate it
slightly to the right first then push the base onto the shaft at the top of the handle; rotate it to the
left to lock the head into position.
Use the cleaning brushes alone or with your own detergent or cleaning solution. Move the brush
heads slowly over the surface to be cleaned. Rinse the brush heads clean after each use to remove
any dirt, grime and soap residue.
