Cooper&Hunter CH-IRT05NM, Service Manual, Page: 37 / 110

Rooftop Packaged Service Manual INSTALLATION
34
INSTALLATION
1 UNITS INSTALL
1.1 INSTALLATION POSITIONS
To ensure the unit in proper function, selection of installation location must be in accordance with
following principles.
(1) Unit shall be installed so that the air discharged by outdoor fan will not return and that sufficient
space for repair shall be provided around the unit.
(2) The installation site must have good ventilation, so that the unit can take in and exhaust enough
air.
(3) Place of installation shall be strong enough to support the weight of unit, and it shall be able to
insulate noise and prevent vibration. Ensure that the wind and noise from the unit will not affect
your neighbors.
(4) Avoid direct sunshine over the unit. It is better to set up a sun shield as the protection.
(5) Place of installation must be able to drain the rainwater and defrosting water.
(6) Place of installation must ensure the unit will not subject to the influence of rubbish or oil fog.
(7) The installation site must be at a place where the air exhaust outlet does not face strong wind.
(8) Unit must be fixed on stable and solid surface of floor.
1.2 MATTERS NEED ATTENTION
1.2.1 PRE-INSTALLATION INSTRUCTION
Upon receiving the product, check any damage from transportation. Shipping damage is the
responsibility of the carrier. Verify the model number, specifications and accessories are correct prior to
installation. The distributor or manufacturer will not accept claims from dealers for transportation damage
or installation of incorrectly shipped units.
If the checking is passed, protecting measure should be adopted. Do not open the packing too early, in
order to avoid damage
1.2.2 LIFTING METHOD