Customer First Center 1121 Highway 74 South Peachtree City, GA 30269 770.486.4800 FAX 770.486.4801
INSTALLATION INSTRUCTIONS
IMPORTANT
: READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN FOR FUTURE REFERENCE
LD4A/LD6A Emergency
Commercial Recessed Installation
Instructions
706084INS
4/04/13
page 1
PORTFOLIO
®
ADP132108
STEP 1:
To prevent electrical shock and unintentional battery
discharge, do not join the unit connector until the
installation is complete. Immediately prior to
permanently turning the A.C. power on, engage
the connector on the battery pack assembly.
STEP 2:
This fixture provides more than one power supply
output source. To reduce the risk of electrical shock,
disconnect both normal and emergency sources
by turning off the A.C. branch circuit and by
disconnecting the connector on the battery pack
assembly.
STEP 3:
The emergency source requires an unswitched A.C.
power source of either 120 or 277 volts. Properly cap
the unused A.C. lead (Refer to wiring diagram).
STEP 4:
This unit is for recessed ceiling mounting only. Do not
use outdoors, in hazardous locations, or near gas or
electric heaters.
STEP 5:
This is a recessed ceiling mounted LED unit with
standby batter operation. In normal mode the LED
will be fully illuminated. In the emergency mode the
LED will provide emergency illumination for a minimum
of 90 minutes in accordance with the UL 924
standard.
STEP 6:
The test switch and indicator light may be provided
for ceiling mounting near the fixture in a single gang
switch box (Figure 1) or mounted on the housing in
an adjustable bracket to position directly in a
reflector (Figure 2).
STEP 7:
When used in insulated ceilings, insulation must be
kept off of the unit and no closer than 3” from the
unit on all sides.
STEP 8:
Do not use this equipment for other than the
intended use.
STEP 9:
Install only in accordance with National Electric Code
and local regulatory agencies requirements.
STEP 10:
Installation and servicing to be performed only by
qualified personnel.
Risk Of Electrical Shock
Disconnect power at fuse
or circuit breaker before
installing or servicing.
WARNING
!
Risk Of Fire
Do not install insulation
within 3 inches (76 mm) of
any part of the luminaire
fixture or in a way that
may entrap heat.
WARNING
!
Figure 1
Installation:
Figure 2
Servicing: