Installation Instructions for:
ATLANTIC and ATLANTIC PLUS
1
1
2
x4
Ear
th (i
f req
uire
d)
Neu
tral
L1 (
Uns
witc
hed
)
L2 (
Swi
tche
d)
L2
L1
N
L2
L1
N
Remove Diffuser
Remove Geartray
Remove all packaging before installation.
F
Mounting
Cable Entries
Ensure mounting fixings are watertight.
Use BESA, or drill mounting holes:
Glands must be waterproofed by applying a thin layer of grease to the
flange & threads.
Use cable entry knockouts:
Press diffuser
onto bulkhead
FIRMLY to
secure all
four clips
Remove connector
from transport clamp
Fit the connector into the
elevated holder
Earth terminal provided
for looping-in only
Cable Routing
Re-assembly
CLASS 2 fitting
Wiring
290
1
0
0
3
3
2
2
Due to the high operating temperature of some components on the
printed circuit board (PCB) it is essential that the incoming mains cable
is kept clear of the PCB and its components.
If the lamp is to be continuously alight link L2 to L1.
Connection to L2 not required for non-maintained operation.
See note overleaf regarding EMC requirements.
1
Caution
DO NOT MEGGA after installation. In accordance with IEE regulation 613-7 and ECA/LIF recommendations, disconnect live and neutral wires before
insulation resistance check. This is most easily done by removing the geartray.
