Roundel
2
Warning
These installation instructions are valid with the above Ametrix styles.
Sheet 1 of 2
1
Visor and Non-Visor
3
that all sources of power are turned off. All
performed by a certified electrician.
: Before starting any work ensure
work must meet local/national codes and be
Do not
mount fixtures vertically.
Installation Instructions
Vault
C-Scroll
Small, OUTDOOR
P1R
(P
endant
, 1
-way
, R
emote ballast
)
ADY071467 REV B(ECN80481)
with canopy.
(2x)
set screw
(2x)
set screw
#10-32 x3/8"
4.
Secure canopy using both #10-32 x3/8" set screws.
3.
To seal door, refer to torque sequence supplementry page.
1.
After securing fixture to ceiling, attach appropriate wires
and ensure all connections are properly matched.
2.
Push wire connections into j-box and cover mounting plate
#6-32 x1/2"
#6-32 x5/8"
set screw
Securing fixture to ceiling
indicator
(2x)
When fixture head is rotated to desired angle, retighten end
screws to secure the position.
#10-32 x5/8"
End screw
Fixture head
degrees
2.
1.
To aim fixture, loosen both #10-32 x5/8" end screws. When
both indicators are lined up, the slope of the lens face is 40-
degrees. Each subsequent notch is an addi/- 10-
Yoke arm
indicator
(x4)
(2x)
Set screw
Use
J-box
Canopy
mounting plate.
Aiming the fixture
#8-32 x 3/8"
Using appropriate fasteners, secure fixture to ceiling.
(by others)
Run wires from pendant and j-box through wiring holes in
(by others)
4.
additional bracing around J-box to support fixture.
1.
Using both #10-32 x5/8" end screws, secure fixture head to
yoke on pendant and run wire through compression fitting
and into pendant.
2.
Remove both #10-32 x3/8" set screws and allow canopy to
slide down pendant.
3.
1/4" fasteners
Use additional bracing
around J-box to support
fixture.
(by others)
1/4" fasteners
J-box
#8-32 x3/8"
Set screw
#6-32 x1/2"
Set screw
Canopy
(2x)
#6-32 x 5/8"
(by others)
End screw
Set screw
Exploded view and part call-out
Wiring & sealing the fixture
(2x)
(2x)
#10-32 x5/8"
Compression
fitting
