(2x)
#8-32 x3/8"
Set screw
(2x)
Fixture head
End screw
#10-32 x1
Yoke end cap
1/4-20 x3/4"
Yoke assembly
(2x)
Canopy
Hex bolts
1.
Prior to attaching fixture head to cantilever, remove both
#8-32 x3/8" set screws and allow canopy to slide down
pendant.
2.
Feed power wire through wiring holes and using appropriate
fasteners, secure mounting plate to structure.
Wiring the fixture
J-box
(by others)
Mounting cantilever to structure
#8-32 x3/8"
(by others)
Set screw
Canopy
(4x)
Mounting plate
1/4" fastener
Use additional bracing around
J-box to support J-box.
sealing the fixture.
Refer to supplementary sheet for instructions on aiming and
(2x)
#8-32 x3/8" set screws.
Push connections into J-box and secure canopy using both
Wiring holes
Set screws
3.
1.
After pulling wires through wiring holes in mounting plate,
attach appropriate wires and ensure all connections are
properly matched.
2.
#8-32 x 3/8"
Canopy
Warning
Visor and Non-Visor
: Before starting any work ensure
that all sources of power are turned off. All
work must meet local/national codes and be
performed by a certified electrician.
Do not
These installation instructions are valid with the above Ametrix styles.
1
3
2
Sheet 1 of 3
mount fixtures vertically.
Installation Instructions
Vault
C-Scroll
Roundel
Large, OUTDOOR
CR
(C
antilever
, R
emote ballast
)
ADY071481 REV A(ECN080352)
Exploded view and part call-out
mounting plate.
Run wiring from fixture head, into pendant and out holes in
Securing fixture to cantilever
#6-32 x1/4"
Fixture head
(2x)
end cap
Yoke arm
1/4-20 x3/4" hex bolts.
4.
Flat head screw
#10-32 x1"
End screw
With fixture head removed, secure yoke to cantilever using
1.
To remove fixture head from yoke assembly, remove #10-32
x1" end screw from
one
side.
2.
Remove the #6-32 x1/4" Flat head screw from the inside of the
yoke arm and remove the yoke end cap.
3.
1/4-20 x3/4"
Hex bolts
Attention:
All large fixtures require additional bracing/structure
around J-box to support fixture.
