70
www.cooperbussmann.com/wirelessresources
Cooper Bussmann 945U-E Wireless Ethernet Modem & Device Server User Manual
Rev Version 2.14
Owner
Owner name.
Contact
Owner contact information (such as phone number and email address).
Description
Description of the purpose of the unit.
Location
Location description for the 945U-E.
3.24 Configuration Examples
Setting a 945U-E to Factory Default Settings
1. Access configuration webpages on the 945U-E.
For details, see “3.2 Configuring the Unit for the First Time.”
2. Click the
System Tools
menu item.
3. Click
Factory Default Configuration Reset
, and wait for the unit to reset.
While the module executes the reset sequence the OK LED will flash. The OK LED will turn green when the
reset sequence is complete.
Extending a Wired Network
Figure 69 Example Configuration 1
Access Point Configuration
1. Connect a straight-through Ethernet cable between the PC and the 945U-E.
2. Ensure that the configuration of the PC and the 945U-E are setup to communicate on the same network.
3. Set DIP switch to SETUP mode.
4. Power up the unit and wait for the OK LED to stop flashing.
5. Adjust the PC network settings.
6. Set Configuration PC network card with the network setting of IP address 192.168.0.1, netmask 255.255.255.0.
7. Open configuration webpage with Internet Explorer at address 192.168.0.1XX/, where “XX” is the last two
digits of the module’s serial number.
8. When prompted for password, enter default username “user” and password “user.”
9. Click
Network
and select Operating Mode as “Access Point.”