Super 80 Professional – AOM
NORMAL PROCEDURES
Section 3 Page 20
Super 80 Professional – Aircraft Operating Manual
Coolsky, 2018
PRIOR TO ENGINE START OR PUSHOUT
PRIOR TO ENGINE START OR PUSH OUT (Checklist)
GALLEY POWER ....................................................................................................................... OFF
1.
Set the Galley Power switch to OFF.
ENGINE IGNITION ............................................................................................................. CONTIN
2.
Set the Engine Ignition switch to GND START & CONTIN.
FUEL PUMPS ............................................................................................................................... ON
3.
Normally you would turn on all the fuel pumps. However, if the center tanks do not have
any usable fuel, leave them OFF.
AUX HYDRAULIC PUMP ............................................................................................................ ON
4.
Set the Auxiliary Hydraulic Pump switch to ON. Also check that both engine hydraulic
pumps are in the LOW position.
ANTI-COLLITION/EXTERIOR LIGHTS ................................................................. ON/AS REQUIRED
5.
Turn on the anti-collision light to alert ground personnel that the engines are about to be
started.
6.
Set the POS/STROBE light switch to BOTH.
DOOR ANNUNCIATOR ............................................................................................................ OUT
7.
Verify that all door annunciator lights are out.
AIR CONDITIONING SUPPLY SWITCHES ................................................................................. OFF
8.
Set the Air Conditioning switches to OFF. These switches may, at the Captain’s discretion
be left in the AUTO position until just prior to positioning the first engine start switch to
GND.