TABLE OF CONTENT
Table of Contents & How It Works ...........................................1
Installation & Set-Up..............................................................2
Dust Screen & Side Panel ........................................................3
Managing the Water Reservoir ...............................................3
LCD Button Panel & Remote Control .......................................4
Basic Operation & Powering On ..............................................5
CoolBox Controls ....................................................................6-7
Using the Timer Feature .........................................................8
Routine Maintenance .............................................................8
Basic Troubleshooting ............................................................9
Circuit board & Specifications .................................................10
Contact Information ...............................................................11
INSTALLATION AND INITIAL SET-UP
If the fan must be placed close to a wall or other obstacle, try to keep a distance of 2 to 3 feet
between the wall or obstacle and the face of the cooling pads.
When placing the fan, take the following into consideration:
A.
Uninterrupted fresh air should be made available to the cooling pad side of the unit for
best results.
B.
Avoid blocking the air output (front) side of the fan. Cool air released from the unit should
be able to freely circulate.
C.
In order to prevent air from being re-circulated, ensure that the area to be cooled is
properly ventilated.
D.
If your CoolBox did not come with the truckles (the wheel assembly legs) attached, please
see the below instructions on how to do so.
EVAPORATIVE AIR COOLER
CoolAZone.com
HOW COOL-A-ZONE WORKS
Water Distrubutor
Cool-A-Zone’s water reservoirs
hold up to 37 gallons. With
add-on reservoir capacity,
you can run your Cool-A-Zone
longer without refilling!
Cool-A-Zone’s
Evaporative Pad
Cool-A-Zone’s beltless,
direct-powered stainless
steel fan.
HOT AIR
COMES IN
COOL AIR
COMES
OUT
TRUCKLE UNATTACHED
TRUCKLE ATTACHED
Truckle Attaching Points
Finished Assembly
1.
Take two sets the Truckles (above left, shown unattached).
2.
Use the enclosed ST5×25 bolts to stable the assembled frame to the bottom of the water
tank through the attaching points as shown on the left which will line up with
corresponding points on the unit.
3.
When completed, the finished truckle-body assembly area should look as shown above on
the right.
1
2
CZ-C100 Manual-rev.indd 2
8/1/12 10:48 AM
