Requirements
♦
Configure and activate the frame buffers by selecting the Configuration menu in
the first drop down menu and Frame Buffer in the second drop down menu. Then
select Frame Buffer in the menu displayed (refer to Chapter 9.4.2).
♦
An event that you assigned the recording in a frame buffer as an action has
occurred.
If the above requirements have been met, the images stored in this buffer will be
displayed.
Figure 16: Displaying the images in the frame buffer
1. Select a camera (frame buffer).
2. The pre event images are displayed at the top, the first image is displayed
enlarged in the center of the window and the post event images are displayed at
the bottom.
3. Clicking on an image will enlarge it.
)
Note: The frame buffers are automatically restarted as soon as your images are
sent by email or VdS 2465 message. The next pre event images will then be
displayed. A frame buffer that was activated but not sent will not be restarted. In this
case, all the pre event and post event images will be displayed.
State
This menu displays a status overview of the 6 frame buffers (red indicator = started,
black indicator = stopped).
Manual
- 31 -
